Abstract:Conventional adhesives often emit volatile organic compounds (VOCs) because of using toxic raw materials in the production and these VOCs have a negative impact on human health. In this paper, a series of adhesives with low VOCs emission and high shear strength are prepared from 3,4‐dihydroxybenzaldehyde and polyethyleneimine by a reaction which has produced Schiff base. Conventional adhesives often emit volatile organic compounds (VOCs), which have a negative impact on human health. In this paper, an environmentally‐friendly supramolecular adhesive PD which has high adhesive and low VOCs emission is prepared by the reaction between polyethyleneimine (PEI) and 3,4‐dihydroxybenzaldehyde (DBA). PD containing abundant catechol groups exhibit excellent adhesion to wood substrates and is able to reach a maximum shear strength of 5.20 ± 0.39 MPa. One factor is attributed to multiple reactions between PEI, and DBA and oxidation of DBA. These reactions construct a complex three‐dimensional cross‐linked structure which is very helpful to improve the bonding performance of the adhesive. Another reason refers to the fact that a large number of catechol groups in PD can form a lot of hydrogen bonds with the amino group in PEI and the hydroxyl group in the wood substrate. These hydrogen bonds play an important role in enhancing shear strength. PD adhesives have a stronger bond strength than commercial chloroprene rubber (CR, Pattex‐PXL) and polyvinyl acetate adhesives (PVAc, JUJU‐8708) and have lower emissions of VOCs. As an environmentally‐friendly adhesive for wood‐based substrates, this adhesive may have potential applications in the wood processing industry.

Development of New Environmental Friendship Building Putty Powdered Adhesive and Its Application

Preparation and Experimental Study on A New Type of Exterior Wall Putty

Study on Improve Interface Tensile Adhesive Property of Extruded Polystyrene Board with Acrylate Emulsion

Preparation and Properties of Environmentally-friendly Modified Furfural Epoxy Grouting Materials

Research Progress of Emulsion Adhesives

The Performance Characteristics of Sand Wall-like Architectural Coatings and Construction Technology for Imitation Exterior Wall Brick

Interactions Between Organic and Inorganic Phases in PA- and PU/PA-Modified-Cement-Based Materials

Special Polymer Latex Acronal EIFS 5235ap for Adhesive and Basecoat Mortars of Exterior Insulation and Finishing System

Research on Interfacial Bonding Properties and Engineering Applications of Polymer Modified Mortar

Fabrication of Novel Crosslinking Carboxylic Styrene-Acrylate Latices As Binders for Exterior Flexible Facing Tiles

An easy-coating, versatile, and strong soy flour adhesive via a biomineralized structure combined with a biomimetic brush-like polymer

Preparation optimization by response surface and performance characterization of PEG-urea-dialdehyde starch adhesive

An eco‐friendly and high shear strength adhesive from catechol‐modified polyethyleneimine

Mechanical properties and anti-efflorescence of cement-based coating containing silicon-aluminum based powder and modified-polyacrylate emulsion

Epoxy Resin Adhesives: Modification and Applications

Folic Acid-Based Coacervate Leading to a Double-Sided Tape for Adhesion of Diverse Wet and Dry Substrates

Fabrication and application of a new type of plasters

Functionalization of cellulose with amine group and cross-linked with branched epoxy to construct high-performance wood adhesive

Effect of powder–liquid ratio and admixture on properties of metakaolin‐based geopolymer coating

Feasibility Study on the Utilization as Repair Grouting of High Flowable Polymer-Modified Cement Mortar, Adding High Volume Polyacrylic Ester (PAE)

Experimental Study on Modification of Grouting Material for Joints of Prefabricated Buildings