Abstract:We report detailed degradation and rejuvenation studies of AC electroluminescence (EL) of the phosphor ZnS:Cu,Cl, aiming to better understand the physical mechanisms that control EL emission. We find that the AC EL emission spectra vary considerably with the AC driving frequency but all spectra can be fit to a sum of four Gaussians. During degradation, although there is a large overall decrease in amplitude, the shape of the emission spectra measured at a given AC frequency does not change. Annealing the samples after they are significantly degraded can rejuvenate the phosphors with a maximum rejuvenation occurring (for fixed annealing times) near 180 °C. Further, these test cells can be degraded and rejuvenated multiple times. However studies at slightly higher annealing temperatures (240 °C) show significant thermal degradation and, perhaps more importantly, a change in the spectral shape; this likely indicates that two distinct mechanisms are then operative. In extended x-ray absorption fine structure (EXAFS) experiments we find that the CuS nanoprecipitates in the ZnS host (∼ 75% of the Cu is in the CuS precipitates) do not change significantly after the 240 °C anneal; these experiments also provide a more detailed comparison of the local structure about Cu in pure CuS, and in ZnS:Cu,Cl. In addition, the EXAFS experiments also place an upper limit on the fraction of possible interstitial Cu sites, proposed as a blue emission center, at less than 10%. The combined experiments place strong constraints on the mechanisms for degradation and rejuvenation and suggest that EL degradation is most likely caused by either Cu or Cl diffusion under high E-fields, while thermal diffusion at slightly elevated temperatures without E-fields present, re-randomizes the (isolated) dopant distributions. Higher T anneals appear to damage the sharp tips on the precipitates.

Influence of Mechanical Milling and Annealing Atmosphere on the Photoluminescence Properties of ZnS:Cu,Cl Phosphors

High wurtzite content ZnS:Mn with better luminescent performances prepared at lower temperature by a ball milling method

Improved Electroluminescence Performance of ZnS:Cu,Cl Phosphors by Ultrasonic Treatment

Synthesis of Two-Dimensional Micron-Sized Single-Crystalline ZnS Thin Nanosheets and Their Photoluminescence Properties

Preparation of the ZnS-type Electroluminescent Phosphor Used in Flat Panel Display Field

Effect of Activator Distribution on Photo- and X-ray Excited Luminescence Properties of ZnS:Cu,Cl Phosphors

Microstructural and Luminescence Characteristics of High-Linearity ZnS:Cu2+,Cl− Phosphor

Photophysical and photoluminescence properties of co-activated ZnS:Cu,Mn phosphors

Near-Infrared Long-Persistent Phosphor of Zn3ga2ge2o10: Cr3+ Sintered in Different Atmosphere

Effect of rapid thermal annealing on photoluminescence and crystal structures of CdZnO films

Effect of Rapid Thermal Annealing Ambient on Photoluminescence of Zno Films

Effect of complexing agent and annealing atmosphere on properties of nanocrystalline ZnS thin films

Thermostimulated luminescence and photoluminescence of microcrystalline zinc sulphide ZnS:Cu

An Investigation on AC Electroluminescent Properties of ZnS: Cu Powder

Effects of sintering temperature and phase transition on the photoluminescence and triboluminescence of manganese doped zinc sulfide

Luminescence Characteristics of Impurities-Activated Zns Nanocrystals Prepared in Microemulsion with Hydrothermal Treatment

Luminescence Properties of ZnSxO1-x:Ce3+ Phosphors with Tunable Short Fluorescence Lifetime

Influence of annealing atmosphere and temperature on photoluminescence of Tb3+ or Eu3+-activated zinc silicate thin film phosphors via sol–gel method

Synthesis and Luminescent Modulation of ZnS Crystallite by a Hydrothermal Method

Degradation and rejuvenation studies of AC electroluminescent ZnS:Cu,Cl phosphors

A new method for preparing cubic-shaped Sr2MgSi2O7: Eu2+, Dy3+ phosphors and the effect of sintering temperature