Abstract:We report detailed degradation and rejuvenation studies of AC electroluminescence (EL) of the phosphor ZnS:Cu,Cl, aiming to better understand the physical mechanisms that control EL emission. We find that the AC EL emission spectra vary considerably with the AC driving frequency but all spectra can be fit to a sum of four Gaussians. During degradation, although there is a large overall decrease in amplitude, the shape of the emission spectra measured at a given AC frequency does not change. Annealing the samples after they are significantly degraded can rejuvenate the phosphors with a maximum rejuvenation occurring (for fixed annealing times) near 180 °C. Further, these test cells can be degraded and rejuvenated multiple times. However studies at slightly higher annealing temperatures (240 °C) show significant thermal degradation and, perhaps more importantly, a change in the spectral shape; this likely indicates that two distinct mechanisms are then operative. In extended x-ray absorption fine structure (EXAFS) experiments we find that the CuS nanoprecipitates in the ZnS host (∼ 75% of the Cu is in the CuS precipitates) do not change significantly after the 240 °C anneal; these experiments also provide a more detailed comparison of the local structure about Cu in pure CuS, and in ZnS:Cu,Cl. In addition, the EXAFS experiments also place an upper limit on the fraction of possible interstitial Cu sites, proposed as a blue emission center, at less than 10%. The combined experiments place strong constraints on the mechanisms for degradation and rejuvenation and suggest that EL degradation is most likely caused by either Cu or Cl diffusion under high E-fields, while thermal diffusion at slightly elevated temperatures without E-fields present, re-randomizes the (isolated) dopant distributions. Higher T anneals appear to damage the sharp tips on the precipitates.

Preparation of the ZnS-type Electroluminescent Phosphor Used in Flat Panel Display Field

Synthesis of Two-Dimensional Micron-Sized Single-Crystalline ZnS Thin Nanosheets and Their Photoluminescence Properties

Influence of Mechanical Milling and Annealing Atmosphere on the Photoluminescence Properties of ZnS:Cu,Cl Phosphors

Improved Electroluminescence Performance of ZnS:Cu,Cl Phosphors by Ultrasonic Treatment

[Influence of Parameters of ZnS Film on the Organic/inorganic Composite Luminescence Devices].

An Investigation on AC Electroluminescent Properties of ZnS: Cu Powder

High wurtzite content ZnS:Mn with better luminescent performances prepared at lower temperature by a ball milling method

Study of Preparation of Low Voltage Cathodoluminescent Phosphor and Application on Field Emission Display Screen

Electroluminescence From Doped Zns Nanocrystals Polymer Composite Systems

Study on ZnGa2O4:Cr3+ A.c. Powder Electroluminescent Device

Microstructural and Luminescence Characteristics of High-Linearity ZnS:Cu2+,Cl− Phosphor

Luminescence Properties And Energy Transfer Of Ce3+,Tb3+-Coactivated-Sialon Phosphors

Electroluminescent Characteristics of CdSe Colloidal Quantum Dots

Degradation and rejuvenation studies of AC electroluminescent ZnS:Cu,Cl phosphors

Study Of Nanocrystalline Zinc Oxide Phosphor For Field Emission Display

Luminescence Properties of ZnS O1-:Ce3+ Phosphors with Tunable Short Fluorescence Lifetime

Silica encapsulated ZnO quantum dot-phosphor nanocomposites: Sol-gel preparation and white light-emitting device application

Cathodoluminescent Properties Of Nanocrystalline Lu3ga5o12:Tb3+ Phosphor For Field Emission Display Application

Cathodoluminescent Properties of SrGa2S4:Eu2+ Phosphor for Field Emission Display Application

Electroluminescence from ZnS/CdS nanocrystals/polymer composite

Luminescence of rare earth doped ZnS nanophosphors for the applications in optical displays