Abstract:The tribological performance of copper-based powder metallurgical material is much influenced by the interfacial bonding between the components and matrix. By adding Cu-coated or uncoated graphite particles as a lubricant, two types of copper-based powder metallurgical materials were prepared via spark plasma sintering (SPS). The hardness, relative density, and thermal conductivity of the two specimens were firstly measured. Using an inertial braking test bench and temperature measuring instrument, the average friction coefficients, instantaneous friction coefficients, and friction temperatures of the two specimens were tested under different test conditions, and the wear rates were calculated accordingly. Based on the analysis of surface morphologies and elements distribution after the tests, the mechanisms of wear and formation of friction films were discussed. The results show that with the lubricant of Cu-coated graphite, the hardness, relative density, thermal conductivity, and interfacial bonding between the graphite and matrix can be greatly improved. Under the same test condition, the average friction coefficient, wear rate, and friction temperature of the specimen with added Cu-coated graphite are both lower than those of the specimen with added uncoated graphite. The two specimens show different variation trends in the instantaneous friction coefficient during the tests, and the variation of the instantaneous friction coefficient at a high initial test speed is also different from that at a low initial test speed for each specimen. The two specimens also show differences in the continuity of friction film and the content of graphite and oxide in the friction film.

A Study on the Friction and Wear Properties of Ceramic-Enhanced Cu-Based Composites

A Comparative Investigation of the Tribological Behavior and Wear Mechanism of Bronze-graphite Composite under Dry- and Water-lubricated Sliding Against Steel

Study of Friction and Wear Properties of Cu/Short Carbon Fibers Composites

Study on the Tribological Performance of Copper-Based Powder Metallurgical Friction Materials with Cu-Coated or Uncoated Graphite Particles as Lubricants

Study on friction and wear behaviors of ceramic-graphite composite

Study on the tribological properties of MoB/Cu laminated composite materials fabricated by hot-pressing process

Friction and wear behavior of CuFe3Al powder metallurgical composites in dry sliding

Study on friction and wear behavior of copper fibers in semimetallic friction materials

Mechanical and tribological property of Cu/CrB 2 composites under dry sliding condition

Tribological behavior of aluminum matrix composites reinforced with ceramic particulates in dry sliding against a semimetallic friction material

Study on the Tribology Properties of the Particles/Cu Composite Coatings

Effect of Cr–Fe on friction and wear properties of Cu-based friction material

Study on Friction Properties of Cu-Based Friction Materials with Ni Coated Nano-Sio2 Particles

Tribological and Wear Properties of Cu-Based Composite Reinforced by Core–Shell Structure in Multi-disk Clutch

Influence of Steel Fiber on Mechanic and Tribological Properties of Cu-Based Cermet Friction Material

On the tribological behaviors of Cu matrix composites with different Cu-coated graphite content

Enhancement mechanism of carbon fiber on the current-carrying tribological properties of Cf-Al2O3/Cu composites

Effect of Cu content on the microstructure and properties of sintered Fe-0.8C-xCu antifriction materials

The Microstructure and Wear Characteristics of Cu–Fe Matrix Friction Material with Addition of SiC

Investigation of the tribological mechanisms of TiN-ZrO 2 -B 4 C ternary ceramic-reinforced copper-metal matrix composites

Influences of B 4 C and carbon nanotubes on friction and wear performance of Cu base self-lubricating composite