Abstract:Nanometer-sized SnO(2) powders was synthesized at low decomposing temperature by polyacrylamide gel method. SnCl, was used as starting material, acrylamide and N, N'-methylenediacrylamide were used as initiator and lattice reagent. The best condition to prepare gel and the optimal temperature decomposed were studied by controlling the reagent concentration, weight ratio of the reactants, temperature. The prepared powders were analyzed by XRD, TEM, and FT-1R. The results showed that the even size of SnO(2) powders is 25-35nm, the specific surface is 28-38m(2)/g. There are no impurity peaks in products spectrogram analyzed by infrared spectrum analysis which is sintered at 500 degrees C when the ratio of initiator and lattice reagent is 5: 1. As the crystallization tends to be completely, corresponding 666cm-1 absorption peak strength is enhanced. Through the TEM analysis, we can see that the products have sphere-like particles, small particle diameter, uniform particle size distribution and good dispersion property as well as no obvious hard agglomeration when the the ratio of initiator and lattice reagent is 5:1 Based on XRD analyzing, only a single phase belonged to the nanometer SnO(2) powders is observed, and no extraneous phase is emerged when the reactants is sintered at 500 degrees C and the ratio of initiator and lattice reagent is 5:1 for the polyacrylamide gel method.

Synthesis of Tin Oxide Nanoparticles by Impinging Stream Reaction

Preparation of SnO2 Nanoparticles by Homogeneous Precipitation Method

Synthesis of Tin Oxide Nanoparticles by Precipitation Process: Effects of pH and Temperature on the Particle Size and Morphology

Synthesis of Tin Oxide Nanoparticles by Mechanochemical Reaction

Synthesis of Nanocrystalline SnO2 Powders with Oxidation of Granulated Tin-hydrothermal Method

Hydrothermal Synthesis of Tin Oxide Nanoparticles

Preparation and Characterization of SnO_2 Nanoparticles

Preparation Of Nano-Sized Tin Oxide By Polyacrylamide Gel Method

Preparation of Nanosized SnO2 by Liquid-Phase Direct Precipitation Method

Preparation Of Tin Oxide Nanoparticles By Laser Ablation In Solution

The Preparation Technology of SnO<sub>2</sub> Nanowires Based on the System of Al-SnO-Cu<sub>2</sub>O

Tin oxide nanocrystal synthesized by mechanochemical method

Facile and Surfactant-Free Route to Nanocrystalline Mesoporous Tin Oxide

Preparation of Nanocrystalline Tin Dioxide Particles via the Acrylamide Polymerization Process

Study on the Preparation and Properties of Nanometer SnO_2/TiO_2 Mixed Oxides

Preparation of Nanometer Rutile TiO2 Particles by High Temperature Gas Phase Reaction

Preparation of Tin Oxide Nanoparticles Using A Sol-Gel Process Based on Tin Dichloride and Absolute Ethanol

Hydrothermal Preparation and Characterization of Nanocrystalline Porous Tin Dioxide Thin Films

Synthesis and Characterization of Nanocrystalline Tin Oxide by Sol–gel Method

Sintering Of Tin Oxide Nanoparticles Synthesized By Hydrothermal Method

Large-scale synthesis of rutile SnO2 nanorods