Abstract:Currently, relatively large errors are found in numerical results in some low-specific-speed centrifugal pumps with unshrouded impeller because the effect of clearances and holes are not accurately modeled. Establishing an accurate analytical model to improve performance prediction accuracy is therefore necessary. In this paper, a three-dimensional numerical simulation is conducted to predict the performance of a low-specific-speed centrifugal pump, and the modeling, numerical scheme, and turbulent selection methods are discussed. The pump performance is tested in a model pump test bench, and flow rate, head, power and efficiency of the pump are obtained. The effect of taking into consideration the back-out vane passage, clearance, and balance holes is analyzed by comparing it with experimental results, and the performance prediction methods are validated by experiments. The analysis results show that the pump performance can be accurately predicted by the improved method. Ignoring the back-out vane passage in the calculation model of unshrouded impeller is found to generate better numerical results. Further, the calculation model with the clearances and balance holes can obviously enhance the numerical accuracy. The application of disconnect interface can reduce meshing difficulty but increase the calculation error at the off-design operating point at the same time. Compared with the standard k-ɛ, renormalization group k-ɛ, and Spalart-Allmars models, the Realizable k-ɛ model demonstrates the fastest convergent speed and the highest precision for the unshrouded impeller flow simulation. The proposed modeling and numerical simulation methods can improve the performance prediction accuracy of the low-specific-speed centrifugal pumps, and the modeling method is especially suitable for the centrifugal pump with unshrouded impeller.

Investigation on the Secondary Flow Structures and Jet-Wake Structure of the Eckardt's Impeller

Les and Cdns Investigation of T106c Low Pressure Turbine

Numerical Computation of the Eckardt Impeller and the Comparisons With Its Experimental Results

Large Eddy Simulation of Secondary Eddy for Impinging Jet

Numerical Simulation of Flow in Centrifugal Pump with Complex Impeller

Numerical Simulation of Inner Flow Field in Centrifugal Impeller with Long, Middle and Short Blades

Large-eddy Simulation and Analysis of Turbulent Flow in Axial Pump Impeller

Investigations into the unsteady internal flow characteristics for a waterjet propulsion system at different cruising speeds

Numerical Investigation on Flow Field of Impeller Front-Side Cavity for Shrouded Impeller

NUMERICAL STUDIES ON THE PROPULSION AND WAKE STRUCTURES OF FINITE-SPAN FLAPPING WINGS WITH DIFFERENT ASPECT RATIOS

Numerical study of the hydrodynamic performances of surface piercing propeller

Wind Tunnel Experiment and Numerical Simulation of Secondary Flow Systems on a Supersonic Wing

Study on Inlet Flow Field Structure and End-Wall Effect of Axial Flow Pump Impeller under Design Condition

Investigation of CFD Calculation Method of a Centrifugal Pump with Unshrouded Impeller

Turbulent flows in tubular pump and fluid-structure interaction characteristics of impeller

Investigation Of The Secondary Flow Structure In The Mixed Flow Turbine For A High Pressure Ratio Turbocharger

Three-Dimensional Simulation of Turbulent Rectangular and Square Impinging Jet Flows

Numerical Simulation of Internal Flow Field of an Unshrounded Centrifugal Impeller in a Low Specific Speed Pump

3-D Steady Turbulence Flow Numerical Simulation on the Full Passage of a Counter-Rotating Axial Flow Pump

NUMERICAL SIMULATION OF LAMINAR SQUARE IMPINGING JET FLOWS