Abstract:<p>Fully developed turbulent flow of water in a square duct has been studied with thermography of the 25 μm heated steel foil that covers part of the duct wall. Thermal fluctuations observed in the specific case fall in-between the ideal isothermal boundary condition, which is achieved with a thick heater cooled with water, and ideal isoflux boundary condition, which could be theoretically achieved with an infinitely thin heated foil. Results in the present paper are obtained at fixed Reynolds number 10000 and heat flux at the thin foil around 6 kW/m<sup>2</sup>, which was considered to be the upper limit, where the water can be treated as a passive scalar at Prandtl number 5.4 with temperature increments around 5 °C above the inlet value. Main experimental results are 2D temperature fields on the outer side of the foil, which were averaged over time to predict the mean foil temperature, temperature fluctuations and the corresponding spectra. These parameters provide accurate description of the turbulence near the heated foil. Simple geometry of the experiment and fully developed velocity field are convenient for accurate numerical simulation, which was performed with wall-resolved Large Eddy Simulation approach. Average magnitude of the measured and computed temperature fluctuations was roughly 0.5 °C and 0.6 °C, respectively, which corresponds to about 10% of the temperature increment. Measured thermal streak spacing was around 60 wall units, and was together with the power spectra of the temperature fluctuations in close agreement with the LES numerical predictions that included the foil with conjugate heat transfer. Despite the square cross-section of the duct, which contains around dozen thermal streaks on each side of the duct, the spectra and the streak spacing remain similar as in the channel flow between the parallel planes.</p>

Temperature Dissipation Measurements in a Fully Developed Turbulent Channel Flow

Equivalence of Three Thermal Boundary Conditions in Compressible Turbulent Channel Flows

Observation of Heat Transfer in Oscillating Flow Within A Circular Channel

On the Measurement of Lateral Velocity Derivatives in Turbulent Flows

Temperature Dissipation In A Turbulent Round Jet

Direct numerical simulations of compressible turbulent channel flows with asymmetric thermal walls

Measuring time-resolved heat transfer fluctuations on a heated-thin foil in a turbulent channel airflow

Experimental and Numerical Flow Visualizations of Mixed Convection with Flow Reversal in a Horizontal Channel with Constant Wall Temperature

Total and static temperature statistics in compressible turbulent plane channel flow

Differentially heated turbulent channel flow two-point correlations

Measurements of the Thermal Dissipation Field in Turbulent Rayleigh-Bénard Convection.

Locally Averaged Thermal Dissipation Rate in Turbulent Thermal Convection: A Decomposition into Contributions from Different Temperature Gradient Components

Measurements of a Turbulent Channel Flow with Smooth and Rough Surfaces

Effect Of Wire Separation On X-Probe Measurements In A Turbulent-Flow

Simulation of heating of the sensitive element of the heat flux sensors in a high-velocity flow under variable input conditions

Analysis of Real-Fluid Thermodynamic Effects on Turbulent Statistics in Transcritical Channel Flows

A Unified Temperature Transformation for High-Mach-number Flows above Adiabatic and Isothermal Walls

On the Measurement of Wall-Normal Velocity Derivative in a Turbulent Boundary Layer

Investigation of turbulent flow in square duct with heated foil thermometry

Compressibility Effects on Hypersonic Turbulent Channel Flow with Cold Walls

Conjugate heat transfer in spatial laminar-turbulent transitional channel flow