Abstract:We report the high peak power picosecond hybrid fiber and solid-state laser amplifier system. The passively mode-locked solid-state seed source produced an average power of 1.8 W with pulse width of 14 ps and repetition rate of 86 MHz. It was directly coupled into the first Yb-doped polarized photonic crystal fiber amplifier stage. To avoid the nonlinear effects in fiber, the output power from the first stage was merely amplified to 24 W with the narrow spectra broadening of 0.21 nm. For the improvement of the peak power, the dual-end pumped composite Nd:YVO4 amplifier system has been chosen at the second stage. To reduce the serious thermal effect, the thermally bonded composite YVO4 – Nd:YVO4 – YVO4 rod crystal was used as the gain medium. The 53 W TEM00 mode with the peak power of 40 kW, beam quality of M2 < 1.15, corresponding to the optical-optical efficiency of 42.4% was obtained at the hybrid amplifier laser system. The system allows using a low power seed source and demonstrates an increase in the peak power beyond a fiber master oscillator power amplifier's (MOPA's) limit.

High-power Continuous-Wave Output of Master Oscillator Power Amplifier System at 1053 and 1083 Nm

Fiber-solid, Hybrid, Single-Frequency Laser (100 W) with a 100 MHz Repetition Rate and 1 Ns Pulse Width from a Spherical Aberration Compensated Four-Stage Nd:YVO4 Amplifier

1010 nm Directly LD-Pumped 6kW Monolithic Fiber Laser Employing Long-Tapered Yb3+-Doped Fiber

High-energy single-frequency pulsed fiber MOPA at 1064 nm based on a hybrid active-fiber

175-W Continuous-Wave Master Oscillator Power Amplifier Structure Ytterbium-Doped All-Fiber Laser

A 4.8-kW high-efficiency 1050-nm monolithic fiber laser amplifier employing a pump-sharing structure

End-Pumped 300 W Continuous-Wave Ytterbium-Doped All-Fiber Laser With Master Oscillator Multi-Stage Power Amplifiers Configuration

Hybrid-structure 1018-Nm Monolithic Single-Mode Fiber Laser Producing High Power and High Efficiency

High Power Diode-Side-Pumped 1 112-Nm Nd:Yag Laser Based on Master-Oscillator Power-Amplifier System

High Peak Power Picosecond Hybrid Fiber and Solid-State Amplifier System

All-fiber single frequency pulsed amplifier with 412 W peak power output operating at 1030 nm

700 W single-frequency all-fiber amplifier at 1064 nm with kHz-level spectral linewidth

High-Power High Beam Quality Narrow-Linewidth Quasicontinuous Wave Microsecond Pulse 1064-Nm Nd:YAG Amplifier

First Experimental Investigation of the Amplification of a Yb-doped Fiber Laser Pumped with 1000 and 1014-Nm Laser Diodes

High Power Efficient 3.81 $\mu{\rm M}$ Emission from a Fiber Laser Pumped Aperiodically Poled Cascaded Lithium Niobate

All-fiberized master oscillator power amplifier structured narrow-linewidth nanosecond pulsed laser with 505 W average power

High-power CW 1048 nm Yb:YAG Dual-Ended Diode-pumped zigzag slab Laser

High power, continuous-wave, single frequency fiber amplifier at 1091 nm and frequency doubling to 545.5 nm

100 MW Peak Power Picosecond Laser Based on Hybrid End-Pumped Nd:YVO4 and Side-Pumped Nd:YAG Amplifiers

219.6 W large-mode-area Er:Yb codoped fiber amplifier operating at 1600 nm pumped by 1018 nm fiber lasers

Single-frequency pulsed laser source with hybrid MOPA configuration