Abstract:In this paper, a path loss characterization at millimeter-wave (mmWave) frequencies is performed in a typical indoor office environment. Path loss results were derived from propagation channel measurements collected in the 25–40 GHz frequency band, in both line-of-sight (LOS) and obstructed-LOS (OLOS) propagation conditions. The channel measurements were performed using a frequency-domain channel sounder, which integrates an amplified radio over fiber (RoF) link to avoid the high losses at mmWave. The path loss was analyzed in the 26 GHz, 28 GHz, 33 GHz and 38 GHz frequency bands through the close-in free space reference distance (CI) and the floating-intercept (FI) models. These models take into account the distance dependence of the path loss for a single frequency. Nevertheless, to jointly study the distance and frequency dependence of the path loss, multi-frequency models were considered. The parameters of the ABG (A-alpha, B-beta and G-gamma) and the close-in free space reference distance with frequency path loss exponent (CIF) models were derived from the channel measurements in the whole 25–40 GHz band under the minimum mean square error (MMSE) approach. The results show that, in general, there is some relationship between the model parameters and the frequency. Path loss exponent (PLE) values smaller than the theoretical free space propagation were obtained, showing that there are a waveguide effect and a constructive interference of multipath components (MPCs). Since the measurements were obtained in the same environment and with the same configuration and measurement setup, it is possible to establish realistic comparisons between the model parameters and the propagation behavior at the different frequencies considered. The results provided here allow us to have a better knowledge of the propagation at mmWave frequencies and may be of interest to other researchers in the simulation and performance evaluation of future wireless communication systems in indoor hotspot environments.

Characterization of the ORBIT Indoor Testbed Radio Environment.

300 GHz Wideband Channel Measurement and Analysis in a Lobby

Upper Mid-Band Channel Measurements and Characterization at 6.75 GHz FR1(C) and 16.95 GHz FR3 in an Indoor Factory Scenario

Empirical Characterization and Modeling of the Propagation Channel Inside the VIRC

Ray-Optics Simulations of Outdoor-to-Indoor Multipath Channels at 4 and 14 GHz

Millimeter-Wave Channel Measurements and Path Loss Characterization in a Typical Indoor Office Environment

Propagation measurements and channel models in Indoor Environment at 6.75 GHz FR1(C) and 16.95 GHz FR3 Upper-mid band Spectrum for 5G and 6G

Outdoor-to-Indoor 28 GHz Wireless Measurements in Manhattan: Path Loss, Environmental Effects, and 90% Coverage

Measurement and Simulation for Improving Indoor Wireless Communication System Performance at 2.4 GHz by Modifying the Environment

Measurement Campaign on 5G Indoor Millimeter Wave and Visible Light Communications Multi Component Carrier System

Propagation Measurement and Channel Characteristics of Small Office OAM Communication at 30 GHz

Measurement on 2.3GHz wideband indoor MIMO channel based on dual polarization antennas

Wireless Channel Characterization from 2 to 28 GHz in an Outdoor Parking Lot

Indoor Office Plan Environment and Layout-Based MmWave Path Loss Models for 28 GHz and 73 GHz

Millimeter Wave and Sub-THz Indoor Radio Propagation Channel Measurements, Models, and Comparisons in an Office Environment

3D MIMO Outdoor-to-Indoor Propagation Channel Measurement

Path Loss and Directional Gain Measurements at 28 GHz for non-Line-of-Sight Coverage of Indoors with Corridors

Characterization of Indoor RIS-Assisted Channels at 304 GHz: Experimental Measurements, Challenges, and Future Directions

3D Channel Propagation in an Indoor Scenario with Tx Rooftop & Wall at 3.5 & 6 GHz

Near-Field Measurement System for the Upper Mid-Band