Abstract:Structural Health Monitoring, Ahead of Print. Welding is a commonly used method for joining two or more parts together in steel construction. Various defects in weld regions such as cracks, pores, and slag inclusion can be present from the beginning, generated during the welding process, or can be developed while in service. Such defects are the weak spots that degrade the structure's quality and can lead to structural failures. Therefore, early detection of these defects in welded joints, before visible cracks appear, is very important. Using appropriate ultrasonic non-destructive testing and evaluation (NDT&E) techniques, one can detect these defects and take remedial actions to prevent catastrophic structural failures. Guided acoustic wave-based techniques have been proven to be effective for damage detection in steel pipes and rods. Several studies have previously attempted to detect damage in steel tubes using guided ultrasonic waves. Unlike earlier attempts which mostly focused on conventional linear ultrasonic techniques, a relatively new nonlinear ultrasonic technique called sideband peak count-index (SPC-I) is carried out in this research. For this investigation, cast steel components and round hollow structural sections are welded together, and a four-point bending test is conducted under fatigue loading. The welded joints are continuously monitored in real time using strain gages and lead zirconate titanate (PZT) transducers. The PZT transducers are used to generate and receive guided acoustic waves. The signal is propagated through the specimen in a single-sided transmission mode setup. The strain gage readings and the nonlinear ultrasonic parameter, the SPC-I values, are monitored simultaneously. The results obtained from the nonlinear ultrasonic NDT&E measurements are compared with the data obtained from the strain gages to determine the robustness and reliability of the SPC-I technique for monitoring welded joints. This investigation also shows the potential effectiveness of the nonlinear ultrasonic parameter SPC-I for early detection of weld failure.

PZT-Induced Lamb Waves and Pattern Recognition for On-Line Health Monitoring of Jointed Steel Plates

PZT-based active damage detection techniques for steel bridge components

Detection and Quantification of Damage in Metallic Structures by Laser-Generated Ultrasonics

ULTRASONIC LAMB WAVES APPLIED IN NONDESTRACTIVE DAMAGE EVALUATION

Health Monitoring of Stiffened Metallic Plates Using Nonlinear Wave Interaction and Embedded PZT Transducers

Experimental Study of Static and Dynamic Loading Effects on Guided Wave-Based Intelligent Monitoring of Welded Rail Joints

Health Monitoring of Steel Structures Using Impedance of Thickness Modes at Pzt Patches

Abuilt-in Active Sensing System-Based Structural Health Monitoring Technique Using Statistical Pattern Recognition

Nondestructive Testing Method Based on Lamb Waves for Localization and Extent of Damage

Early detection of steel tube welded joint failure using SPC-I nonlinear ultrasonic technique

Damage Diagnostics on A Welded Zone of A Steel Truss Member Using an Active Sensing Network System

Guided wave based SHM for loosening detection in bolted lap joints with the application of Neural Networks

Damage Detection of Composite Plates by Lamb Wave Ultrasonic Tomography with a Sparse Hexagonal Network Using Damage Progression Trends

Damage Detection Method Based on Continuous Wavelet Transformation of Lamb Wave Signals

Integrated Structural Health Assessment Using Piezoelectric Active Sensors

Lamb Wave Based Multistage Damage Detection Method

Nonlinear Guided Wave Tomography for Detection and Evaluation of Early-Life Material Degradation in Plates

Quantitative Structural Damage Detection Using High-Frequency Piezoelectric Signatures Via The Reverberation Matrix Method

IMPACT DAMAGE DETECTION IN COMPOSITE LAMINATE PLATES USING AN INTEGRATED PIEZOELECTRIC SENSOR AND ACTUATOR COUPLE COMBINED WITH WAVELET-BASED FEATURES EXTRACTION APPROACH

Application of Damage Detection of Metal Structure Lamb Wave Modal Superposition Imaging Based on Scanning Laser Vibration Measurement

Lamb-Wave-Based Multistage Damage Detection Method Using an Active PZT Sensor Network for Large Structures.