Abstract:(Pbx,Sr1−x )0.85Bi0.1TiO3 thin films with the perovskite phase structure were prepared on an ITO glass substrate by sol-gel method. X-ray diffraction (XRD), scanning electron microscopy (SEM) and an impedance analyzer were respectively used in order to characterize the phase status, morphology and dielectric properties of the thin films. The results show that during the formation process of (Pbx,Sr1−x )0.85Bi0.1TiO3 thin films, the nucleus of the perovskite phase are initially formed and then congregated. These aggregated nucleus are then transformed as the perovskite-phase crystalline in the thin film. Finally, the crystalline phase grows and separates gradually to form the perfect crystalline-phase structure. The content of the perovskite phase formed in the thin film under rapid thermal process (RTP) is more than that formed under traditional heat treatment with kinetic equilibrium. This is due to the high active decomposed ions that form the perovskite phase directly when heat-treated by RTP. The formation of the perovskite phase therefore overcomes a much lower barrier under RTP than that under traditional calcinations. The structure of the perovskite phase has a close relation to the ratio of Pb/Sr in the system because of the radius difference between Pb2+ and Sr2+. The transformation temperature between the cubic and the tetragonal structures of the perovskite phase increases with increasing Pb2+ content because the radius of Pb2+ is larger than that of Sr2+. It appears at room temperature when the content of Pb2+/Sr2+ is about 40/60 in the thin film. Meanwhile, the tetragonality of the perovskite phase is increased when Pb2+ ions increase due to its high polarization. The higher tunability of the (Pbx,Sr1−x )0.85Bi0.1TiO3 thin film is exhibited when the film composition is close to the transformation point between the paraelectric and ferroelectric phases. Pb2+ ions show a dominant factor to affect the Curie point of the system and then changing tunability.

Effect of Lead Excess on the Formation and Dielectric Properties of Silver Dispersed Lead Titanate Film

Effect of PbO Excess on the Microstructure, Dielectric and Piezoelectric Properties, and Energy-Storage Performance of Bi(Ni1/2Ti1/2)O3–PbTiO3thin Films

Effect of dispersed Ag on the dielectric properties of sol–gel derived PbTiO3 thin films on ITO/glass substrate

Influence Of Pb Excess On The Properties Of Lead Lanthanum Titanate Ferroelectric Thin Films On Pt And Lanio3 Electrodes

Formation of Silver Nano Particles in Percolative Ag‐PbTiO 3 Composite Dielectric Thin Film

The Effect of Dual Complexing Agents of Lactic and Citric Acids on the Formation of Sol-Gel Derived Ag–PbTiO3 Percolative Thin Film

Formation of Ag Nanoparticles in Percolative Ag–PbTiO3 Composite Thin Films Through Lead-Rich Ag–Pb Alloy Particles Formed As Transitional Phase

Structural and Abnormal Electrical Properties of Excess PbO-doped Lead Lanthanum Titanate Thin Films

Pinning Effect of Lead Lanthanum Titanate Thin Films Deposited on Different Substrates

Effect of La-Introduced Manner on the Phase Formation and Morphology of the Hydrothermally Synthesized Pb_(0.70)La_(0.30)TiO_3 Powders

Effect of Bottom Electrodes on Structures and Electric Properties of Plt Ferroelectric Thin Films

Hydrothermal Synthesis and Morphology Evolution of Perovskite PbTiO<sub>3</sub> Crystals with Different Lead Sources

Influence of Excess of Lithium Source on Electrochemical Performance of Li_4Ti_5O_(12)

Effect of Incorporation of Silver on the Electrical Properties of Sol-Gel-Derived Titania Film

Behavior of Lead Ions in Cassiterite Flotation Using Octanohydroxamic Acid

Effect of the Molecular Weight of Dispersant to the Slurry for Lead-Free Transparent Dielectric Films

Effect of Lead Oxide Compounds on Microstructure and Critical Current Density of (Bi,pb)-2223/Ag Tapes

Effects of Pb–B–Si–O Glass on the Microstructures and Electrical Properties of Silver Electrode for LTCC Application

Effect of lead on formation and dielectric tunability of (Pb<sub>x</sub>,Sr<sub>1− <i>x</i> </sub>)<sub>0.85</sub>Bi<sub>0.1</sub>TiO<sub>3</sub> thin films

Effect of Lead Oxide Compounds on the Microstructure and Properties of Bi-2223/Ag Tapes

Combined Effect of Preferential Orientation and Zr/Ti Atomic Ratio on Electrical Properties of Pb(ZrxTi1−x)O3 Thin Films