Abstract:According to the tetrahedral phase diagram of LiNiO₂–LiCoO₂–LiMnO₂–Li₂MnO₃, a series of Li₁.₂(Ni₀.₂Mn₀.₆)ₓ(Co₀.₄Mn₀.₄)y(Ni₀.₄Mn₀.₄)₁₋ₓ₋yO₂ (0 ≤ x + y ≤ 1) have been designed to explore new Li-rich solid solution cathode materials. The effects of Li₁.₂Ni₀.₂Mn₀.₆O₂, Li₁.₂Co₀.₄Mn₀.₄O₂ and Li₁.₂Ni₀.₄Mn₀.₄O₂ content in solid solutions on structure and electrochemical properties are investigated. Micro-sized spherical or ellipsoidal precursors are first prepared via a carbonate co-precipitation route. After calcination with lithium sources, all samples are indexed to a typical layered structure with an R3m space group as detected by X-ray diffraction (XRD). It is found that the introduction of Co can improve the tap density. However, these Co referred samples reveal lower discharge specific capacities and inferior cycle life. For these Co-free materials with high Ni content, for instance Li₁.₂Ni₀.₃Mn₀.₅O₂, although low capacity is observed in the initial cycle, a large capacity of above 250 mA h g⁻¹ is achieved after about 10 cycles. Importantly, the activated Li₁.₂Ni₀.₃Mn₀.₅O₂ material still delivers a high capacity of over 230 mA h g⁻¹ after 70 cycles, displaying superior cycle stability. These results may be instructive in designing and exploring high performance cathode materials for advanced LIBs.

Preparation of Li1+Y-Xznxmn2-Yo4 Spinel As A Cathode Material for Li+-Batteries

Spinel Li1 + Xmn2o4 Synthesized by Coprecipitation As Cathodes for Lithium-Ion Batteries

Preparation of Submicrocrystal LiMn2O4 Used Mn3O4 As Precursor and Its Electrochemical Performance for Lithium Ion Battery

Synthesis and Electrochemical Properties of Sc-Doped Li1.05scxmn2-Xo4 Spinel As Cathodic Material for Rechargeable Li-Battery

Optimization Of Spinel Li1+Xmn2-Yo4 As A 4 V Li-Cell Cathode In Terms Of A Li-Mn-O Phase Diagram

Synthesis And Electrochemical Performance Of Linixmn2-Xo4 Spinel As Cathode Material For Lithium Ion Batteries

Preparation of Spherical Spinel LiMn<sub>2</sub>O<sub>4</sub> Cathode Material for Lithium Ion Batteries

Synthesis and Electrochemical Characteristics of Li₁.₂(Ni₀.₂Mn₀.₆)ₓ(Co₀.₄Mn₀.₄)y(Ni₀.₄Mn₀.₄)₁₋ₓ₋yO₂ (0 ≤ X + Y ≤ 1) Cathode Materials for Lithium Ion Batteries

Studies on an LiMnO Spinel System (obtained by Melt-Impregnation) As a Cathode for 4 V Lithium Batteries Part 1. Synthesis and Electrochemical Behaviour of LixMn2O4

Lithium Manganese Spinel Cathodes for Lithium‐Ion Batteries

Optimization of Spinel Li[sub 1+x]Mn[sub 2−y]O[sub 4] as a 4 V Li-Cell Cathode in Terms of a Li-Mn-O Phase Diagram

Synthesis and Electrochemical Performance of LiNi0.5Mn1.5O4 Spinel Compound

Studies on LiMnO spinel system (obtained from melt-impregnation method) as a cathode for 4 V lithium batteries Part II. Optimum spinel from γ-MnOOH

Electrochemical Studies of Substituted Spinel LiAlyMn2−yO4−zFz for Lithium Secondary Batteries

Dependence of Battery Performance of Spinel Li{sub 1+x}mn{sub 2}o{sub 4} on the Preparation Method

Preparation of spherical spinel LiMn 2O 4 cathode material for lithium ion batteries

Preparation and performance of Mg-doped spinel-structured LiMn2O4 cathode materials

Dependence of Battery Performance of Spinel Li1+XMn2O4 on the Preparation Method

Surface Modification Mechanism of Spinel Structure LiM_xMn_(2-x)O_4 As Cathode Materials for Lithium Ion Batteries

Preparation of Spinel LiMn2O4 from Manganese Oxide and Its Electrochemical Performance

Novel Synthesis Process and Structural Characterization of Li–Mn–O Spinels