Abstract:The front-end electronics (FEE) of the Compact Muon Solenoid (CMS) is needed very low power consumption and higher readout bandwidth to match the low power requirement of its Short Strip application-specific integrated circuits (ASIC) (SSA) and to handle a large number of pileup events in the High-Luminosity Large Hadron Collider (LHC). A low-noise, wide bandwidth, and ultra-low power FEE for the pixel-strip sensor of the CMS has been designed and simulated in a 0.35 µm Complementary Metal Oxide Semiconductor (CMOS) process. The design comprises a Charge Sensitive Amplifier (CSA) and a fast Capacitor-Resistor-Resistor-Capacitor (CR-RC) pulse shaper (PS). A compact structure of the CSA circuit has been analyzed and designed for high throughput purposes. Analytical calculations were performed to achieve at least 998 MHz gain bandwidth, and then overcome pileup issue in the High-Luminosity LHC. The spice simulations prove that the circuit can achieve 88 dB dc-gain while exhibiting up to 1 GHz gain-bandwidth product (GBP). The stability of the design was guaranteed with an 82-degree phase margin while 214 ns optimal shaping time was extracted for low-power purposes. The robustness of the design against radiations was performed and the amplitude resolution of the proposed front-end was controlled at 1.87% FWHM (full width half maximum). The circuit has been designed to handle up to 280 fC input charge pulses with 2 pF maximum sensor capacitance. In good agreement with the analytical calculations, simulations outcomes were validated by post-layout simulations results, which provided a baseline gain of 546.56 mV/MeV and 920.66 mV/MeV, respectively, for the CSA and the shaping module while the ENC (Equivalent Noise Charge) of the device was controlled at 37.6 e- at 0 pF with a noise slope of 16.32 e-/pF. Moreover, the proposed circuit dissipates very low power which is only 8.72 µW from a 3.3 V supply and the compact layout occupied just 0.0205 mm2 die area.

A CMOS Current-Mode Active Pixel Sensor for High Energy Physics and Biomedical Imaging Applications

A Full Functional Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector

Simulations and Performance Studies of a MAPS in 65 nm CMOS Imaging Technology

CMOS pixel sensors optimized for large ionizing dynamic

Towards a New Generation of Monolithic Active Pixel Sensors

Monolithic Active Pixel Sensors (MAPS) in a quadruple well technology for nearly 100% fill factor and full CMOS pixels

Sensor design optimization of innovative low-power, large area MAPS for HEP and applied science

A Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector

Color Bosonization, Chiral Parametrization of Gluonic Field and QCD Effective Action

A monolithic active pixel sensor with node-based, data-driven, parallel readout for the high energy physics experiment vertex detector

A Simulation System and Its Applications for Signal Readout of CMOS Pixel Sensors in High Energy Physics Experiments

MAPS sensor for radiation imaging designed in 180 nm SOI CMOS technology

Characterization of Fully Depleted CMOS Active Pixel Sensors on High Resistivity Substrates for Use in a High Radiation Environment

A Five-Transistor Active Pixel Sensor with a Wide Dynamic Range and a High-Speed Pixel Operation

Development of a Depleted Monolithic CMOS Sensor in a 150 nm CMOS Technology for the ATLAS Inner Tracker Upgrade

CMOS MAPS with a Novel Readout Scheme for High Luminosity Particle Colliders

NAPA-p1: monolithic nanosecond timing pixel for large area sensors, designed for future e + e - colliders

Depleted Fully Monolithic Active CMOS Pixel Sensors (DMAPS) in High Resistivity 150~nm Technology for LHC

An 8.72 µW Low-Noise and Wide Bandwidth FEE Design for High-Throughput Pixel-Strip (PS) Sensors

Cross-talk of a large-scale depleted monolithic active pixel sensor (DMAPS) in 180Â nm CMOS technology

Cross talk of a large-scale depleted monolithic active pixel sensor (DMAPS) in 180 nm CMOS technology