Abstract:Purpose The velocity head is usually neglected in the energy equation for a pipeline junction when one-dimensional (1D) hydraulic transient flow is solved by method of characteristics. The purpose of this paper is to investigate the effect of velocity head on filling transients in a branched pipeline by an energy equation considering velocity head. Design/methodology/approach An interface tracking method is used to locate the air–water interface during pipeline filling. The pressured pipe flow is solved by a method of characteristics. A discrete gas cavity model is included to permit the occurrence of column separation. A universal energy equation is built by considering the velocity head. The numerical method is provisionally verified in a series pipeline and the numerical results and experimental data accord well with each other. Findings The numerical results show that some differences in filling velocity and piezometric head occur in the branched pipeline. These differences arise because the velocity head in the energy equation can become an important contributor to the hydraulic response of the system. It is also confirmed that a local high point in the profile is apt to experience column separation during rapid filling. Significantly, the magnitude of overpressure and cavity volume induced by filling transients at the local high point is predicted to increase with the velocity in the pipes. Originality/value The velocity head in the energy equation for a pipeline junction could play an important role in the prediction of filling velocity, piezometric head and column separation phenomenon, which should be given more attention in 1D hydraulic transient analysis.

Influence and Numerical Simulation of Local Head Losses on Pressured Conduit Hydraulic Transients

Numerical Simulation of Tunnel Flow with a Concave-Convex Boundary

Numerical Simulation of Serial Sudden Expansions Pipe Flow

A Numerical Study on the High-Velocity Impact Behavior of Pressure Pipes

Numerical simulation of 3-D turbulent flows in a cut-off valve and analysis of flow characteristics in pipe

Attenuation Analysis of Hydraulic Transients with Laminar-Turbulent Flow Alternations

Influence of local energy loss at junctions on hydraulic calculation of pipeline network

Experiment and Numerical Simulation on Hydraulic Loss and Flow Pattern of Low Hump Outlet Conduit with Different Inlet Water Rotation Speeds

Local head loss caused by valves in water distribution network

Numerical Simulation of Flow Pressure Drops for Complex Pipe Segment

Study on optimal water hammer protection for high-head and multi-undulation water conveyance system and empirical formulae for pressure head at nodes

Study of Resistance Distribution and Numerical Modeling of Water Hammer in a Long-Distance Water Supply Pipeline

Local Energy Loss at Junction of Pressurized Pipes with Rectangular Cross Section

Simulation of water distribution systems in hydraulic transient conditions

Transient Simulation Of Hydropower Station With Consideration Of Three-Dimensional Unsteady Flow In Turbine

Numerical simulation of dynamic flow around wicket gate in hydro turbine with guide vane closure

Influence of Velocity Head on Filling Transients in a Branched Pipeline

Numerical Simulation of the Transient Process of Power Failure in A Mixed Pump

Experimental study on local flow resistance at junctions of circular pipes

Experimental study and 3-D numerical simulation on water flow in Y-type pipe

Numerical Simulation on Hydraulic Characteristics of Bifurcated Pipe of a Pumped Storage Hydropower Station