Abstract:The three-dimensional (3D) viscoelastic polymer melt filling process in injection molding has always been regarded as a challenging two-phase flow problem. Numerical investigations concerning it are very limited, especially under the non-isothermal condition. Thus, this article presents a 3D non-isothermal two-phase model to investigate the flow-induced stresses during the viscoelastic fluid filling process. The viscoelastic behavior of polymer melt is predicted by the eXtended Pom-Pom (XPP) model, in which the temperature dependence of polymeric viscosity and relaxation times are described using the Arrhenius equation. The 3D governing equations are solved by a collocated finite volume method. The high resolution revised level set method coupled with a domain extension technique is extended to capture the 3D melt front interface in an irregular cavity. The collocated finite volume method and the revised level set solver are respectively validated using the XPP melts past a cylinder and the single vortex flow. Then the ability of the presented 3D two-phase model is verified by the isothermal Newtonian fluid filling process in a thin rectangular cavity. The numerical results are in good agreement with those reported in literature. Finally, the challenging problem of non-isothermal XPP fluid filling process in a 3D rectangular cavity with one cylindrical insert is investigated. The temperature field, flow-induced stresses and the corresponding rheological behaviors of polymer melt during 3D filling process are quantitatively predicted. Especially, the effects of processing conditions and energy source term on the two normal stress differences are discussed. It is found that melt temperature and injection velocity are the main factors that affect the normal stress differences. The obtained results should be helpful for improving the product properties in practical production. (C) 2016 Elsevier Ltd. All rights reserved.

Prediction of Heat Conduction with Phase-Change Effects During Cooling Stage of Injection Molding of High-Density Polyethylene: Approximate Integral Approach

Numerical Prediction of Phase‐change Heat Conduction of Injection‐molded High Density Polyethylene Thick‐walled Parts Via the Enthalpy Transforming Model with Mushy Zone

Numerical Simulation on the Cooling Stage for Injection Molded Parts of Crystalline Plastics

Simulation of Phase‐change Heat Transfer During Cooling Stage of Gas‐assisted Injection Molding of High‐density Polyethylene Via Enthalpy Transformation Approach

Numerical simulation of filling flow of polymer melt in injection molding

New Approach to Develop a 3D Non-Isothermal Computational Framework for Injection Molding Process Based on Level Set Method

Heat Transfer in Injection Molding of Crystalline Plastics

Fast prediction of crystallinity in injection molding during the packing stage

Three-dimensional Simulations of Non-Isothermal Transient Flow and Flow-Induced Stresses During the Viscoelastic Fluid Filling Process

Integrated Simulation of Fluid Flow and Heat Transfer in Injection Molding for the Prediction of Shrinkage and Warpage

Numerical Simulation of Flow-Induced Stresses in Mold Filling Process Using a Three-Dimensional Two-Phase Flow Model

Probing Solidification Kinetics of High-Density Polyethylene During Injection Molding Using an In-Situ Measurement Technique

Simulations of Three-Dimensional Thermal Residual Stress and Warpage in Injection Molding

A Simple Method for Forecast of Cooling Time of High‐density Polyethylene During Gas‐assisted Injection Molding

Modelling and simulation of moving interfaces in gas-assisted injection moulding process

Simulation of Residual Stress in Viscoelastic Mold Filling Process

Heat Transfer During Solidification of Polyethylene Terephthalate (PET) in Injection Molding

Three-dimensional transient finite element cooling simulation for injection molding tools

A Novel Method for Predicting Degrees of Crystallinity in Injection Molding During Packing Stage

Analysis of thermal residual stress in plastic injection molding

Melt Temperature Profile Prediction for Thermoplastic Injection Molding