Abstract:The tailoring by the process of the properties developed in the plastic objects is the more effective way to improve the sustainability of the plastic objects. The possibility to tailor to the final use the properties developed within the molded object requires further understanding of the relationship between the properties of the plastic objects and the process conduction. One of the main process parameters that allow adjusting the properties of molded objects is the mold temperature. In this work, a thin electrical heater was located below the cavity surface in order to obtain rapid and localized surface heating/cooling cycles during the injection molding process. An isotactic polypropylene was adopted for the molding tests, during which surface temperature was modulated in terms of values and heating times. The modulation of the cavity temperature was found able to control the distribution of relevant morphological characteristics, thus, properties along the sample thickness. In particular, lamellar thickness, crystallinity distribution, and orientation were analyzed by synchrotron X-ray experiments, and the morphology and elastic modulus were characterized by atomic force microscopy acquisitions carried out with a tool for the simultaneous nanomechanical characterization. The crystalline degree slightly increased with the cavity temperature, and this induced an increase in the elastic modulus when high temperatures were adopted for the cavity surface. The cavity temperature strongly influenced the orientation distribution that, on its turn, determined the highest values of the elastic modulus found in the shear layer. Furthermore, although the sample core, not experiencing a strong flow field, was not characterized by high levels of orientation, it might show high values of the elastic modulus if temperature and time during crystallization were sufficient. In particular, if the macromolecules spent adequate time at temperatures close to the crystallization temperature, they could achieve high levels of structuring and, thus, high values of elastic modulus.

Heat Transfer During Solidification of Polyethylene Terephthalate (PET) in Injection Molding

Polymer/mold interfacial heat transfer during injection molding

Probing Solidification Kinetics of High-Density Polyethylene During Injection Molding Using an In-Situ Measurement Technique

Solidification Behavior Of High-Density Polyethylene During Injection Molding Process: Enthalpy Transformation Method

Melt Crystallization Behavior of Injection-Molded High-Density Polyethylene Based Upon a Solidification Kinetic Analysis

Fast prediction of crystallinity in injection molding during the packing stage

Effect of Rapid Mold Heating on the Structure and Performance of Injection-Molded Polypropylene

Investigation of Interface Thermal Resistance between Polymer and Mold Insert in Micro-Injection Molding by Non-Equilibrium Molecular Dynamics

Nonisothermal simulation on pressure during resin transfer molding

The Use of an In-Situ Measurement to Probe the Solidification Kinetics of Injection-Molded HDPE/PP Blends

Numerical Simulation on the Cooling Stage for Injection Molded Parts of Crystalline Plastics

Study on the solidification kinetics of high-density polyethylene during thin-walled injection molding process

Effect of Inhomogeneous Mold Cavity Surface Temperature Rapid Self-Cooling on Β Phase Contents and Mechanical Properties of Injection-Molded Polypropylene

Effect of Melt and Mold Temperatures on the Solidification Behavior of HDPE during Gas-Assisted Injection Molding: An Enthalpy Transformation Approach

Evaluation of thermal contact resistance of molten resin–mold interface during high-thermal-conductivity polyphenylene sulfide filling in injection molding

Simulation of Phase‐change Heat Transfer During Cooling Stage of Gas‐assisted Injection Molding of High‐density Polyethylene Via Enthalpy Transformation Approach

Core Melt Temperature Effects on Cylindritic Structures of Co-Injection Molded Polypropylene Parts

Melt Temperature Profile Prediction for Thermoplastic Injection Molding

Development and Application of a Cooling Rate Dependent PVT Model for Injection Molding Simulation of Semi Crystalline Thermoplastics

Investigation on Solidification Behaviour of High-Density Polyethylene During Thin-Walled Injection Moulding: Correlation Between Crystallisation Kinetics and Thermal Gradient Field