Abstract:Damping is an important factor contributing to errors in the measurement of rotational inertia using the torsion pendulum method. Identifying the system damping allows for minimizing the measurement errors of rotational inertia, and accurate continuous sampling of torsional vibration angular displacement is the key to realizing system damping identification. To address this issue, this paper proposes a novel method for measuring the rotational inertia of rigid bodies based on monocular vision and the torsion pendulum method. In this study, a mathematical model of torsional oscillation under a linear damping condition is established, and an analytical relationship between the damping coefficient, torsional period, and measured rotational inertia is obtained. A high-speed industrial camera is used to continuously photograph the markers on a torsion vibration motion test bench. After several data processing steps, including image preprocessing, edge detection, and feature extraction, with the aid of a geometric model of the imaging system, the angular displacement of each frame of the image corresponding to the torsion vibration motion is calculated. From the characteristic points on the angular displacement curve, the period and amplitude modulation parameters of the torsion vibration motion can be obtained, and finally the rotational inertia of the load can be derived. The experimental results demonstrate that the proposed method and system described in this paper can achieve accurate measurements of the rotational inertia of objects. Within the range of 0–100 × 10−3 kg·m2, the standard deviation of the measurements is better than 0.90 × 10−4 kg·m2, and the absolute value of the measurement error is less than 2.00 × 10−4 kg·m2. Compared to conventional torsion pendulum methods, the proposed method effectively identifies damping using machine vision, thereby significantly reducing measurement errors caused by damping. The system has a simple structure, low cost, and promising prospects for practical applications.

Torsion Pendulum For The Performance Test Of The Inertial Sensor For Astrod-I

Actuation system of the inertial sensor for high-precision space missions using torsion pendulum

Actuation system for inertial sensors in high-precision space missions using a torsion pendulum

A torsion balance as a weak-force testbed for novel optical inertial sensors

An improved magnetic properties measurement scheme using a torsion pendulum

Flexible attitude control design and on-orbit performance of the ZDPS-2 satellite☆

Research on angular vibration measurement system based on heterodyne interference

Laser Micro-Impulse Torsion Pendulum

High-Precision Inertial Sensor Charge Ground Measurement Method Based on Phase-Sensitive Demodulation

Measurement of Flight Object's Moment of Inertia Using Torsion Pendulum

A closed-loop torsional micro-thrust measurement system

Measurements of Magnetic Properties of Kilogram-Level Test Masses for Gravitational-Wave Detection Using a Torsion Pendulum

A torsion pendulum ground test of the LISA Pathfinder Free-fall mode

A torsional thrust stand for measuring the thrust response time of micro-Newton thrusters

Investigation of charge management using UV LED device with a torsion pendulum for TianQin

Design and Test of the Electrostatic Actuation System of the Inertial Sensor for Space Gravitational Wave Detection

Research on the Measurement Technology of Rotational Inertia of Rigid Body Based on the Principles of Monocular Vision and Torsion Pendulum

Current prospects for ASTROD Inertial Sensor

A Newly Designed Decoupling Method for Micro-Newton Thrust Measurement.

Design of electrostatic feedback for an experiment to measure $G$

A New Structure of Test Mass for Ground-used Electrostatically Suspended Accelerometer