Abstract:Effects of the first filling process of the Xiluodu super-high arch dam are studied by both field monitoring and numerical modelling methods. The numerical modelling is conducted by the three-dimensional nonlinear finite element method, which takes into account the nonlinear contact of the transverse joints between dam monoliths and adopts both the design and feedback parameters of the dam. The results obtained from the various numerical analysis cases for different impounded water levels are comprehensively compared with those obtained from the field monitoring. Throughout this study, it is concluded that: (1) changes of the hydrostatic load resulting from the filling process have a significant effect on the deformation and stress states of the dam and foundation. The foundation settles as a consequence of consolidation of the reservoir bed under the effect of the water mass. During the filling process, the compressive stress of the dam in the sealed region increases in the arch direction while that in the cantilever direction decreases, which reveals an enhancement of dam thrust into the two banks. (2) The transverse joints between the dam monoliths are compressed almost over the entire height of the poured dam, and their aperture gradually decreases as the impounded water level increases. (3) The overall deformation of the Xiluodu dam is obviously affected by the uneven foundation settlement due to the complex reservoir basin. The tensile stress concentration appears at the crossing zone of the top of the dam’s sealed region and the dam–foundation interface. Thus, reasonable layout of steel bars and suitable jointing design are essential in these tensile stress concentration regions. (4) The dam behaviour predicted using the three-dimensional numerical modelling is in good agreements with that from the field measuring in terms of the stress and strain distribution characteristics in the dam and foundation, especially when the feedback parameters are adopted for the numerical analysis. The results from both the field monitoring and numerical modelling reveal that overall stability of the dam during the first filling process meets the dam operational requirements.

Effect of Dentated Bucket on Nappe Shape and Impact Pressure Acting on Plunge Pool Floor

Model Test of Water Flow in Bend Chute of Spillway in Fenghuang Reservoir

Hazard and seismic reinforcement analysis for typical large dams following the Wenchuan earthquake

Integrative Study on Flow Characteristics and Impact of Non-Submerged Double Spur Dikes on the River System.

FLOOD DISCHARGE AND ENERGY DISSIPATION BY JETS FROM OUTLETS IN HIGH ARCH DAM

Comparison of Flow Fields of the Arch Inverted Plunge Cushion Pool with the Flat-bottomed Cushion Pool of Xiluodo Arch Dam by Using 3-D Numerical Simulation

Design of Concrete Plug in Foundation Treatment of Arc Dams

Study on A Newtype Plunge Pool of High Arch Dam

Study on the Deformation Mechanism of Abutment Slope and Its Influence on the Dam During the Impoundment of High Arch Dam

TDG generation in a ski-jump spillway with a fully or partial-flip bucket

Experimental Study of the Impact Pressure Distributions in a Stilling Basin During Flood Discharges

Numerical simulation study on spread angle in oblique cut flip bucket

Experimental Study on Failure Mechanism of the Apron Slabs of an Inverted Arch Plunge Cushion Pool under High Water Head and Large Discharge

Performance of Hydrodynamics Flow on Flip Buckets Spillway for Flood Control in Large Dam Reservoirs

Research progress on energy dissipation mechanism and hydrauiic characteristics of piunge pooi in high arch dam

Evaluation and modeling scouring and sedimentation around downstream of large dams

Effect of the Impounding Process on the Overall Stability of a High Arch Dam: a Case Study of the Xiluodu Dam, China

Hydraulics of Wedge-shaped Flip Bucket to Investigate Flow Pattern with Retracted Bottom Plate

Performance analysis of Xiluodu super-high arch dam in impounding period

MECHANISM OF VALLEY DEFORMATION OF HIGH ARCH DAM AND EFFECTIVE STRESS PRINCIPLE FOR UNSATURATED FRACTURED ROCK MASS

Effect of slit size on the impact load against debris-flow mitigation dams