Abstract:Back-to-back pipe bends are widely adopted applications in many industries including nuclear sectors. Evaluation of their load bearing capability under complex cyclic loading is very important. Recently, a couple of research reported shakedown boundary of a 90° back-to-back pipe bends by adopting a conservative approach but no comprehensive post yield structural behaviors have been dealt with. In this research the concerning pipe bends subjected to cyclic opening in-plane (IP)/out-of-plane (OP) bending and steady internal pressures are analyzed to construct shakedown and ratchet limit boundary by means of the Linear Matching Method. Analyzed results present that the concerning pipe bends under out-of-plane bending has higher resistance to cyclic bending than under in-plane bending. In additions, the out-of-plane bending causes very small alternating plasticity areas, unlike the in-plane bending. Full cyclic incremental analyses known as step-by-step analysis are performed to verify the structural responses either side of each boundary and confirm correct responses. Parametric studies are carried out with respect to changes in geometry of the concerning pipe bends subjected to the same loading, and semi-empirical equations are derived from relationships of the reverse plasticity limit and the limit pressure with the bend characteristic. This paper offers broad understandings of structural responses of the 90° back-to-back pipe bends under the complex cyclic loading as well as providing key points to be considered for the life assessment of the piping system.

Elasto-plastic behavior of pipe subjected to steady axial load and cyclic bending

Inelastic behavior of pipe subjected to steady extension and cyclic bending

Load regime diagram of a pipe with cyclically plastic bending

Inelastic behavior of bi-symmetric beams with steady axial force and cyclic bending loads

Elastoplastic Solution of Cylindrical Expansion with Fixed Boundary

Investigating the Effects of Cyclic Thermo-Mechanical Loading on Cyclic Plastic Behavior of a Ninety-Degree Back-to-Back Pipe Bend System

Cyclic Plasticity Behavior of 90° Back-to-Back Pipe Bends under Cyclic Bending and Steady Pressure

Study of plastic limit load of the combined fittings of double elbows under in-plane bending moment

Elastic Buckling of Cylindrical Pipe Linings with Variable Thickness Encased in Rigid Host Pipes

The research on the critical loading path of thick-walled pipes under external pressure and cyclic bending

Buckling Response of Offshore Pipelines under Combined Tension and Bending

A New Approach Of Piping Dynamic Response Considering Plastic Effect

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Buckling Analysis of Plastic Pipe Reinforced by Cross-Winding Steel Wire under Bending

Plastic Collapse Loads for Piping Elbows under In-plane Open/Close Bending Moment

Elastoplastic Pipe-Soil Interaction Analyses of Partially-Supported Jointed Water Mains

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Analysis on Buckling Performance of Submarine Pipelines During Deepwater Pipe-Laying Operation

Behaviour of reinforced thermoplastic pipe under combined bending and external pressure

PLASTIC LIMIT LOAD EQUATIONS OF DEFECT FREE ELBOWS SUBJECTED TO IN-PLANE BENDING MOMENT

Mechanical Behavior of Steel Pipe Bends: An Overview