Abstract:In-doped ZnO nanopowders were prepared by precipitation. The influence of the processing parameters, such as In doping concentration, calcination temperature, reactant ratio and type of precipitant on the grain size, structure and photolumines cence (PL) of In/ZnO nanopowders was detailed analyzed by using X-ray diffraction (XRD) and photoluminescence spectrum. The experimental results indicated that with the increase in the In doping level (the molar ratio of In3+ /Zn2+ increased from 0%. to 5%), the crystallization and the UV emission of ZnO nanopowders were reduced because of the increase of impurity defects. And the UV emission band would have a red-shift from 389 to 419 nm, which could be resulted from the effects of merging of donor and conduction bands, and potential fluctuations of impurity energy level. The calcination temperature will play an important role in synthesis of luminescence materials. When the calcination temperature was raised from 500 to 600 degrees C, the grain size of In/ZnO nanopowder increased gradually, and the dominated UV emission band was improved due to the enhanced crystallization of the nanopowder. If the temperature was raised up to 800 degrees C, the crystallization of the sample was further improved, leading to an enhanced intensity of UV emission Additionally, near this temperature, the oxygen vacancy is easier to be produced owing to the improvement of the kinetic energy for the ions in lattice, which induces in the enhancement of the green emission band peaking at 525 nrn. For the temperature up to 1,000 degrees C, the UV emission band was suppressed due to the production of excessive oxygen vacancy, and the In/ZnO nanopowder exhibited a dominated green emission. The luminescence performance of the In/ZnO nanopowder is also much affected by the reactant ratio. The reaction rate is improved by the increase of the NH4 HCO3 / Zn(NO3)2 molar ratio, which will decrease both grain size of In/ZnO nanopowder and emission intensity of UV band. Furthermore, the effect of the precipitant on the luminescence was examined. It is obviously that the NH4 HCO3 and NaOH precipitants will remarkably affect the crystallization of the precursor powder, but nearly have no effect on the luminescence property of the final nanopowder products.

Preparation and photoluminescence properties of Sb~(3+)-doped ZnO nanophosphors

Preparation and Photoluminescence of ZnO with Nanostructure by Hollow-Cathode Discharge

Study on Photoluminescence of Sb-doped ZnO Nanocrystallites

Preperation and Photoluminescent Properties of Ca2AlSi3O2N5:Sm3+ Phosphor

Preparation and Photoluminescent Properties of Mn-doped ZnS Phosphor Powder Synthesized by Solvothermal Method

Photoluminescence Properties and Threshold Effect of ZnS:Ag Nanoparticles Synthesized by a Hydrothermal Process

Photoluminescence of In-Doped Zinc Oxide Nanopowders Synthesized by Precipitation Method

Microbe-Assisted Synthesis and Luminescence Properties of Monodispersed Tb3+-Doped ZnS Nanocrystals

Microbe-Assisted Synthesis and Luminescence Properties of Monodispersed Tb 3+ -Doped ZnS Nanocrystals

Preparation and Luminescent Properties of Eu3+-doped Zinc Sulfide Nanocrystals

Synthesis and Photoluminescence of Eu3+ and O2- Co-Doped ZnS Nanoparticles with Yellow Emission Synthesized by a Solid-State Reaction

Synthesis and photoluminescent properties of Eu3+-doped ZnGa2O4 nanophosphors

Preparation and optical properties of ZnO/ZnS heterostructured nanomaterials

Photoluminescence Properties of Eu3+-Doped Zns Nanocrystals Prepared in A Water/Methanol Solution

Luminescent Properties of ZnS∶Mn Nanoparticles Dependent on Doping Concentration

Preparation and Luminescence Characteristics of Eu-Doped Nanocrystalline Zinc Oxide

Sb Doping Behavior and Its Effect on Crystal Structure, Conductivity and Photoluminescence of ZnO Film in Depositing and Annealing Processes

Luminescence Characteristics of Impurities-Activated Zns Nanocrystals Prepared in Microemulsion with Hydrothermal Treatment

Effect of lithium doping on the photoluminescence of Sm:ZnO powders

The photoluminescence characteristics of ZnS nanocrystal doped with M3+(M = In, Ga, Al)

Synthesis and Photoluminescence of Y and Cd Co-Doped Zno Nanopowder