Abstract:This article has been retracted: please see Elsevier Policy on Article Withdrawal (http://www.elsevier.com/locate/withdrawalpolicy). This article has been retracted at the request of the Editor-in-Chief. The authors have reused figures and text that have already appeared in their previous articles. Figure 4a duplicates figure 3b of the article that had already appeared in the Journal of Alloys and Compounds 616 (2014) 173–183, http://dx.doi.org/10.1016/j.jallcom.2014.07.143, figure 5b (anticlockwise 90 degrees rotated and horizontally flipped) of the article that had appeared in Materials Characterization 98 (2014) 147–161, http://dx.doi.org/10.1016/j.matchar.2014.10.026, figure 6b of the article published by Surface & Coatings Technology 258 (2014) 467–484, http://dx.doi.org/10.1016/j.surfcoat.2014.08.052 and figure 8b (anticlockwise 90 degrees rotated and horizontally flipped) of the article published by the J. Mater. Sci.: Mater. Med. 26 (2015) 53. https://doi.org/10.1007/s10856-014-5371-5. The article also duplicates parts of the text that appeared in Materials Science & Engineering A 622 (2015) 1–6 http://dx.doi.org/10.1016/j.msea.2014.11.003. One of the conditions of submission of a paper for publication is that authors declare explicitly that their work is original and has not appeared in a publication elsewhere. Re-use of any data should be appropriately cited. As such this article represents an abuse of the scientific publishing system. The scientific community takes a very strong view on this matter and apologies are offered to readers of the journal that this was not detected during the submission process. Journal records indicate that confirmation of the submission and publication of the article was sent to the first author's email address, in addition to an email that used the corresponding author's name (tangguoyiforwork@163.com). The corresponding author and the first author wish to mention that the co-author Zion T.H. Tse was not involved in the preparation and handling of this article. He was not informed about the publication or granted the use of his name and affiliation in the publication. © 2019 Elsevier B.V.

WITHDRAWN: Stability of Vibrations in Cold Rolling under Non-Slip Operating Condition

WITHDRAWN: High Cycle Fatigue Behavior of Extruded Mg–Zn–Y–Zr Alloys Containing Varying Contents of Yttrium

WITHDRAWN: Experimental and Numerical Analysis of Local Reinforced Bolted Composite Joint

RETRACTED: Microstructure and Tribological Characterizations of Ni-based Self-Lubricating Coating

Retracted: Complex Behavior of Droplet Transfer and Spreading in Cold Metal Transfer

WITHDRAWN: UDE-based Chattering-Free Sliding Mode Control for Systems with Mismatched Uncertainties

WITHDRAWN: A Study of the Integrated Composite Material Structures under Different Fabrication Processing

WITHDRAWN: an Elastico-Mechanoluminescence Material CaZnOS:Mn2+ for Sensing and Imaging Various Mechanical Stresses

Withdrawn: Low ice adhesion on soft surfaces: Elasticity or lubrication effects?

WITHDRAWN: Study on Identification Method for Parameter Uncertain Model of Aero Gas Turbine

RETRACTED: Shi et al. Effect of Final Rolling Temperature on Microstructures and Mechanical Properties of AZ31 Alloy Sheets Prepared by Equal Channel Angular Rolling and Continuous Bending. Materials 2020, 13, 3346

WITHDRAWN: Robust Aeroservoelastic Design with Mixed Structural/trim Parameter's Uncertainties

WITHDRAWN: Crystallization, morphology, and dynamic mechanical properties of poly(trimethylene terephthalate)/clay nanocomposites

Retraction notice to: “Effect of electropulsing treatment on microstructure and mechanical properties of cold-rolled pure titanium strips” (Journal of Materials Processing Tech. (2015) 222 (27–32), (S0924013615000850), (10.1016/j.jmatprotec.2015.02.035))

WITHDRAWN: Microstructure and Properties of Welded Joint for T92 Ferritic Heat Resistant Steel

A Numerical Study on Contact Condition and Wear of Roller in Cold Rolling

WITHDRAWN: Reinforcing the Rheological and Mechanical Properties of WPI Nanocomposite Hydrogels with Birefringence Morphologies.

WITHDRAWN: 3D CFD–DEM Simulation on Dense Gas/cylinder-Shaped Particles Flow

RETRACTED: Mathematical Modeling of Mould Temperature Field During Continuous Casting of Steel

WITHDRAWN: Room temperature ferromagnetism in Mn-doped SnO2

WITHDRAWN: Laboratory Study on Mechanical Response and Failure Mechanism of Red-Bed Soft Rock under Water-Rock Interaction