Abstract:This article has been retracted: please see Elsevier Policy on Article Withdrawal (https://www.elsevier.com/about/our-business/policies/article-withdrawal). <This article has been retracted: please see Elsevier Policy on Article Withdrawal (http://www.elsevier.com/locate/withdrawalpolicy). This article has been retracted at the request of the Editor. Figure 5 duplicates figure 8 of the article that had already appeared in Materials Characterization 98 (2014) 147–161, http://dx.doi.org/10.1016/j.matchar.2014.10.026, figure 12 of the paper that had appeared in Applied Physics A 117 (2014) 2251-2264, http://dx.doi.org/10.1007/s00339-014-8655-1, as well as panels from figure 12 of the article that had appeared in the Journal of Alloys and Compounds 616 (2014) 173–183, http://dx.doi.org/10.1016/j.jallcom.2014.07.143. Figure 6 duplicates figure 9 of the article that had already appeared in Materials Characterization 98 (2014) 147–161, http://dx.doi.org/10.1016/j.matchar.2014.10.026 and figure 13 of the article that had appeared in the Journal of Alloys and Compounds 616 (2014) 173–183, http://dx.doi.org/10.1016/j.jallcom.2014.07.143. Figure 7 duplicates figure 10 of the article that had already appeared in Surface & Coatings Technology 258 (2014) 467–484, http://dx.doi.org/10.1016/j.surfcoat.2014.08.052. One of the conditions of submission of a paper for publication is that authors declare explicitly that their work is original and has not appeared in a publication elsewhere. Re-use of any data should be appropriately cited. As such this article represents an abuse of the scientific publishing system. The scientific community takes a very strong view on this matter and apologies are offered to readers of the journal that this was not detected during the submission process. Journal records indicate that confirmation of the submission and publication of the article was sent to the first author's email address, in addition to an email that used the corresponding author's name (guoyitangforwork@163.com). The corresponding author and the first author wish to mention that the co-author Zion T.H. Tse was not involved in the preparation and handling of this article. He was not informed about the publication and he did not grant the use of his name and affiliation in the publication. Prof. S. Petter Lyngstadaas, Dr. Hanna Tiainen and Dr. Sebastian Geissler from University of Oslo are acknowledged for the considerable effort put into collecting the evidence and reporting this case of multiple publication.)> © 2018

RETRACTED: Microstructure and Tribological Characterizations of Ni-based Self-Lubricating Coating

WITHDRAWN: Nanocrystallization kinetics, structure and magnetic properties of FINEMET-type ribbons with Cu substitution by Ag

Retraction Notice to “microstructure, Properties and Temperature Evolution of Electro-Pulsing Treated Functionally Graded Ti-6Al-4V Alloy Strip” [journal of Alloys and Compounds 599 (2014) 1–9]

Retracted: Investigation of Tribological Behaviour on DLC Coatings for AA5051 using DC Sputtering

Retraction notice to “Influence of electropulsing treatment on microstructure and mechanical properties of Ti-6Al-4V alloy strip with lamellar microstructure” [Mater. Sci. Eng. A 622 (2015) 1−6](S0921509314013422)(10.1016/j.msea.2014.11.003)

Retracted: Optimizing the Characteristics of the Laser Hardfacing Process Parameters to Maximize the Wear Resistance of Ni-Based Hard-Faced Deposits Using the RSM Technique

RETRACTED: Structural, mechanical and corrosion resistance properties of Al2O3–CeO2 nanocomposites in silica matrix on Mg alloys by a sol–gel dip coating technique

Retraction notice to: “Effect of electropulsing treatment on microstructure and mechanical properties of cold-rolled pure titanium strips” (Journal of Materials Processing Tech. (2015) 222 (27–32), (S0924013615000850), (10.1016/j.jmatprotec.2015.02.035))

RETRACTED: Effect of Electropulsing Treatment and Ultrasonic Striking Treatment on the Mechanical Properties and Microstructure of Biomedical Ti-6Al-4v Alloy

RETRACTED: Mechanical properties and phase transition of biomedical titanium alloy strips with initial quasi-single phase state under high-energy electropulses

Retraction notice to “ Effects of high-energy electro-pulsing treatment on microstructure, mechanical properties and corrosion behavior of Ti–6Al–4V alloy” [MSEC Volume 49, Year 2015, Pages 851-860](S0928493115000910)(10.1016/j.msec.2015.01.081)

Retraction Note: Effect of Electropulsing Treatment on the Microstructure, Texture, and Mechanical Properties of Cold-Rolled Ti-6Al-4V Alloy

RETRACTED: Nanofibrous Composite Samples Based on a Cu(I) Complex and Its Polymer Host: Synthesis, Characterization and Emissive Performance Improvement

RETRACTED: Vorotilo et al. Manufacturing of Conductive, Wear-Resistant Nanoreinforced Cu-Ti Alloys Using Partially Oxidized Electrolytic Copper Powder. Nanomaterials 2020, 10, 1261

Retracted: Evaluation of MWCNT Particles-Reinforced Magnesium Composite for Mechanical and Catalytic Applications

WITHDRAWN: A Study of the Integrated Composite Material Structures under Different Fabrication Processing

WITHDRAWN: Ferromagnetism in Thin Film and Bulk Mn-doped SnO2

Retracted: Tang Sancai Cultural and Creative Product Design Based on Bi4Ti3O12 Ferroelectric Nanomaterials

Retracted: Influence of Sulfur and Additives on Wear of Exhaust Valve Seat of Cylinder Head

RETRACTED: P-type Zno Thin Films Fabricated by Al–N Co-Doping Method at Different Substrate Temperature

WITHDRAWN: Large-scale Growth of Highly Aligned Silica Nanowires Catalysed by Tin Droplets