Abstract:The steel industry is an important foundation of the national economy and the livelihood of the people, producing a large amount of carbon dioxide gas, accounting for about 70% of the carbon dioxide gas generated in the steel industry, which occurs during the ironmaking process. Therefore, the key technology to reduce the pollution and improve competitiveness is to increase the stability of blast furnace production and the quality of hot metal. Since the operation requirements for temperature control in the vanadium-titanium blast furnace are dramatically different compared to the traditional ones due to the low fluidity of vanadium-titanium slag, maintaining the required hot metal temperature within a narrow range with smaller fluctuations is essential. In addition, the adjustment parameters of the lower part have a significant influence on the tuyere combustion flame temperature during the daily operation of blast furnaces. At present, there is no relevant research on the online detection and analysis of vanadium-titanium blast furnace tuyere combustion flame temperature. In this study, the temperature of four tuyeres in a 500 m3 vanadium and titanium blast furnace at Jianlong Steel was detected by an online detection system. The tuyere combustion flame temperature was then calculated using colorimetric temperature measuring methodology at various times and at four distinct locations. After that, the calibration analyses, imaging parameter and the temperature tendencies in different directions of the blast furnace were investigated. This study not only offers new methods for understanding the regularity of operation and increasing the degree of visualization in vanadium and titanium smelting blast furnaces but also provides technical support for intelligent and low-carbon operation in blast furnaces.

Measurement of the Temperature Uniformity of the Heat-treatment Furnace

Study on Billet Temperature Prediction and Furnace Temperature Optimal Setting of Regenerative Reheating Furnace

Measurements of Quality Variables for an Industrial Rolling Mill Reheating Furnace (II)

FEA simulation research of temperature uniformity in quantitive PCR thermal cycle system

Comparative Analysis for Thermal Utilization Efficiency of Baosteel Sinter Machines

Thermal Performance Testing Device of Automobile Air Conditioning Heat Exchangers for Production Process Quality Control with Application

Analysis of billet temperature non-uniformity in a regenerative reheating furnace: Considering periodic combustion switching and misalignment contact of walking beams

Study on Optimum Position of Temperature Measuring in Heat Exchangers Testing

Comparison of Temperature Difference Measurement Technologies Used in Vehicular Heat Exchangers

Study on Temperature Model and Self-Adaption for Finishing Stands of Hot Strip Mill

Study and optimization on characteristics of temperature field in forced convection oven

STUDY ON TEMPERATURE MEASUREMENT IN COPPER REFINING FURNACE

Heating Temperature and Quality of Marine Forged Steel Parts

Study of Tuyere Combustion Flame Temperature in Vanadium and Titanium Blast Furnaces by Machine Vision and Colorimetric Thermometry

Measurements of Temperature Distribution for High Temperature Steel Plates Based on Digital Image Correlation

Experimental study of the effect of a radiant tube on the temperature distribution in a horizontal heating furnace

The improvement and verification of fluid dynamics simulation on temperature uniformity during heat treatment of ring pieces

The Influence of Heat Treatment on Microstructure Properties of X80 Pipeline Steel

Test And Assessment Of The Heating System Of Reflow Ovens

Modeling and Analysis of Temperature Compensation for Multi-temperature Zone Sintering Furnace Temperature Sensing

Study on the optimization of temperature uniformity in the oven under the forced convection mode