Abstract:Due to the rapid adoption of Electric Vehicles (EVs) worldwide, On-Board/Off-Board Battery Chargers are facing numerous. One challenge is charging time since petrol and diesel vehicles are charged 10 times faster than electric vehicles. A second challenge is power density especially for the on-board chargers where minimal space for installation is allocated inside the vehicles. Another challenge is the wide battery voltage range which makes it difficult to optimize the converter over the entire battery voltage range and efficiency drops when either the battery voltage is too high or too lo.. Finally, the bi-directional operation is a challenge to allow the EV to support the grid in peak periods or even standalone loads. In this paper, a 6.6 kW two-stage structure is proposed utilizing a variable dc-link voltage operation. One of the most promising challenges in high-power applications is implementing the magnetics component into Printed Circuit Boards (PCBs). PCB winding transformers are widely in use in low power applications. Compared with conventional Iitz-wire transformers, the manufacturing process is greatly simplified and the parasitic is easier to control. However, due to the limitation of high winding loss and high multi-layer PCB cost in high power applications, the transformer design with PCB winding becomes a challenge. Emerging wide-bandgap devices provide the opportunity to adopt PCB transformers into high power applications. In addition, the low inductance requirement brought by high frequency also makes possible the realization of magnetic integration in PCB transformers.

Single Cell Charger of Battery Group Based on Magnetic Amplifier and High Frequency Bus

New battery management system for multi-cell li-ion battery packs

A High-Efficiency High-Density Wide-Bandgap Device-Based Bidirectional On-Board Charger

A New Battery Management System for Li-Ion Battery Packs

Design and implementation of a multifunctional management chip for multi-cell Li-ion batteries in series

Bi-directional On-Board Charger Architecture and Control for Achieving Ultra-High Efficiency with Wide Battery Voltage Range

High-Frequency High-Density Bidirectional EV Charger

Design of CRM AC/DC Converter for Very High-Frequency High-Density WBG-based 6.6kw Bidirectional On-Board Battery Charger

V2G Bi-Directional Battery Charger with Flexible AC/DC Converter

Hierarchical State-of-Charge Balancing and Second-Harmonic Current Suppressing Control with a Scalable DC Reconfigurable Battery Pack

Design of Contactless Charging Circuit Based on Magnetic Amplifier

A Winding Multiplexing Method for Single-Phase and Three-Phase On-Board Integrated Battery Chargers Based on Multiphase Motor

An any-cell(s)-to-cell(s) equalization method with a single magnetic component for Lithium-ion battery pack

Li-ion battery management chip for multi-cell battery pack

Improved Multilevel Multistage Constant-Current Constant-Voltage Superfast Charging of Multiple Cells

Design of a bus-based battery equalization with zero-current switching

A High-efficient Battery Charging System for Electric Vehicle

A Fast Primary-Side Current and Voltage Control for Direct Wireless Battery Chargers

Health-aware battery fast charging technique with zonal battery model using pulsed amplitude-width modulation and multi-step constant current constant voltage

Improved Operation and Control of Single-Phase Integrated On-Board Charger System

Adaptive Balancing Control of Cell Voltage in the Charging/Discharging Mode for Battery Energy Storage Systems