Abstract:This paper numerically investigates progressive collapse resistance of three-dimensional steel frames with reinforced concrete slabs exposed to localized fire using LS-DYNA. An explicit dynamic analysis is carried out and the real fire time is scaled down to save the computational cost. The prototype of the model is based on the eight-storey building in Cardington tests. The scenario of heating individual columns on the ground floor is first studied followed by a sever case of simultaneously heating four columns in one compartment. The collapse modes and load redistribution scheme of the frame subjected to different load ratios and fire locations are investigated. The modelling parameters such as mesh size, initial imperfection, timescale are first studied by validating against the fire test data. It is found that the mesh size has little influence on the responses of members at elevated temperature. The initial imperfection has significant effect on the load-bearing capacity of columns. The quasi-static behaviour of structures under a fire duration of hours can be simulated in a dynamic analysis by being scaled to seconds without causing oscillation of responses. The numerical results of the 3D frame show that the frame does not collapse in the case of single column heated for a fire design load (load ratio of 0.25 for columns). By increasing the load ratio to 0.5 as for the ambient design, progressive collapse occurs. For a fire of four columns heated, the frame collapses for the corner bay fire and long edge bay fire but withstands for the internal and short edge bay fires. The collapse modes are dominated by the uneven load redistribution in the two horizontal directions and the fire location, which cannot be simulated by a 2D model. The loads previously sustained by the buckled heated column are transferred more along the short span than the long span. The critical temperature of a column in a frame is significantly lower than that given in EC3, due to the fact that the translational and rotational restraint increase its load ratio and reduce its effective length, respectively. The critical temperature for the global collapse of the frame is about 50-100 degrees C higher than that of individual heated columns. (C) 2016 Elsevier Ltd. All rights reserved.

Limit State of Steel Frames under Fire Conditions

Prediction to Nonlinear Behavior of Steel Frames Subjected to Fire

ULTIMATE LOAD-CAPACITY ANALYSIS OF LIGHT-WEIGHT STEEL PORTAL FRAMES UNDER WIND AND SNOW LOADING

Nonlinear Pre-Fire and Post-Fire Analysis of Steel Frames

Nonlinear Analyses of High-temperature Response for Plane Steel Frame

A Unified Matrix Approach for Nonlinear Analysis of Steel Frames Subjected to Wind or Earthquakes

STABILITY LIMIT STATE ANALYSIS OF STEEL STRUCTURAL MEMBER UNDER FIRE

Experimental, Numerical and Analytical Analysis of a Single-Span Steel Portal Frame Exposed to Fire

FIRE RESPONSES AND RESISTANCE OF CONCRETE-FILLED STEEL TUBULAR FRAME STRUCTURES

Non-linear finite element analysis of axially restrained steel beams at elevated temperatures in a fire

Simulations on Progressive Collapse Resistance of Steel Moment Frames under Localized Fire

Analysis of Planar Frame with Steel Beam-Concrete-filled Steel Tubular Columns after Exposure to Complete Fire Process under Different Fire Cases

Fire Safety Analysis of Plastic Steel Frames

Storey-Based Stability of Steel Frames Subjected to Post-earthquake Fire

Progressive Collapse Analysis of 3D Steel Frames with Concrete Slabs Exposed to Localized Fire

Experimental and Numerical Study on Thermal-Structural Behavior of Steel Portal Frames in Real Fires

Structural Response and Behavior Analyses of Steel Joint Components at Elevated Temperatures

Analyses of Nonlinear Temperature Response of Steel Structures

A Simplified Approach for Fire Resistance Design of High Strength Q460 Steel Beams Subjected to Non-uniform Temperature Distribution

NON-LINEAR ANALYSIS OF ELASTICALLY AXIAL-RESTRAINED 2D STEEL BEAMS AT ELEVATED TEMPERATURES IN FIRE BASED ON ARC LENGTH COORDINATE METHOD

Response of Steel Members Subject to Temperature Gradient in Localized Fires