Abstract:Microwave heating makes utilization of thermal effect produced by energy consumption of high-frequency electromagnetic waves in the interior of substance. Because electrical conductivity and loss factor of substance have close relationship with microwave frequency, temperature, composition, structure and impurity content of the substance, the characteristic of microwave heating have strong selectivity to promote some chemical reactions. The results indicated that TiO2 in the CaTiO3 accounts for 75–84% or so of the whole BF slag bearing titanium in Panzhihua steel Corp. Therefore, the focus of this research is to change current existing state of CaTiO3 in BF slag bearing titanium. That is to say, through alteration of slag components and cooling speed, to seek the condition that crystal granularity and crystallized quantities of CaTiO3 will become bigger, and to treat by microwave heating, all of which helps to separate CaTiO3 from BF slag bearing titanium. The distribution of CaTiO3, whose average diameter is only 41 mm in BF slag bearing titanium, appears to be thin and dispersive, so the research on relative magnetic susceptibility of CaTiO3 and other minerals in slag as well as effective fragmentation method or method of accelerating crystal grains to grow up is necessarily needed. From the perspective of fragmentation, due to low utilization ratio for traditional fragmentation method and hard property of slag bearing titanium which will consume a mass of energy if it is broken into 40 mm in diameter, so some other approaches have to be sought from viewpoint of economic benefits such as slag broken by microwave. The main petrographic minerals in BF slag bearing titanium are various such as CaTiO3, titanaugite, spinel, and so on, all of which have different loss factor, so their absorption ability for microwave is different as well as their heat expansion in which condition heat stress is produced in slag bearing titanium correspondingly. Therefore, as temperature rising rate and temperature reaching a fixed value, it’s theoretically analyzed that crystal grains of CaTiO3 or around them should be made to produce cracks, which will be of benefit to subsequent grinding of BF slag bearing titanium and development of separation technology for CaTiO3.

Heating Behavior of Blast Furnace Slag Bearing High TiO_2 Under Microwave Irradiation

Numerical Simulation on the Heating of Blast Furnace (bf)slag with High TiO2 under Microwave Irradiation

Effect of Microwave Treating the Blast Furnace Slag Bearing Titanium on Thermal Action

Microwave-Assisted Grinding of High TiO_2 Blast Furnace Slag

ISIJ International, Vol. 47 (2007), No. 9, pp. 1239–1244

An investigation of phase transformation of titania slag using microwave heating

Numerical Simulation of the Temperature Field of Titania-Bearing Bf Slag Heated in A Microwave Oven

Effects of mechanical activation on structural and microwave absorbing characteristics of high titanium slag

Multi-scale investigation of the formation and properties of high-grade rutile TiO2 from titanium slags using microwave heating

Study of the oxygen reduction of low valent titanium in high titanium slag by microwave rapid heating

Preparation of synthetic rutile from high titanium slag using microwave heating

Temperature Rising Behavior of Oxide Materials Synthesized V-Al Alloy and Slag after Reaction in Microwave Field

Selective enrichment and extraction of well-catalyzed perovskites on melting-microwave heating process from blast furnace slag

Heating process and damage evolution of microwave absorption and transparency materials under microwave irradiation

Evaluation of the structure and valence state of titanium oxide in titania slag under microwave heating

Probing microscale crystallization phenomena: Transforming waste slags into riches

Study on the High-temperature Properties of High-titania Slags produced with Cr-bearing Vanadia-titania Magnetite Smelting in Blast Furnace

Investigation on drying characteristics of high titanium slag using microwave heating

The effect of TiO<sub>2</sub> on the thermal stability and structure of high acidity slag for mineral wool production

The effect of TiO2 on the thermal stability and structure of high acidity slag for mineral wool production

Analysis and Mechanism Study of Residual Stress during the Spontaneous Crystallisation Process of Molten Titanium-Containing Blast Furnace Slag