Abstract:Laboratory tests were conducted to analyze the geotechnical properties of chemically stabilized municipal solid waste incineration (MSWI) fly ash. The borehole samples were obtained from a landfill in southern China, which covered five different fill ages and three different burial depths. The measurements involved grain-size distribution, relative density, water content, moisture retention capacity, permeability coefficient, compression property, shear strength, etc. The mean diameter was 0.8−3.1 mm, which was close to coarse sand or fine gravel. The non-uniform coefficient and curvature coefficient were 4.56−10.33 and 0.32−0.43, respectively. The stabilized fly ash was poorly graded. The relative density was 1.68−2.56. The moisture content and moisture retention capacity were 16.6%−46.4% and 23.9%−56.7%, respectively. There is water absorbing capacity for the stabilized fly ash. The permeability coefficient was 9.1×10–5−4.5×10–3 cm/s, which decreased with increasing stress. The primary compression ratio and compression coefficient were 0.13−0.18 and 1.21−1.93 MPa–1, respectively. The stabilized fly ash has the property of high compressibility. The cohesive force and friction angle were 14.0−19.5 kPa and 32.9°−34.2°, respectively. The cohesion is mainly contributed by the cementing properties of the stabilized fly ash. The cementitious structure of the stabilized fly ash might be deteriorated with increasing fill age, which resulted in decreases in grain size, relative density, permeability coefficient and shear strength, and an increase in moisture retention capacity. The comparison analysis was conducted between the present results and the references' data for MSW. Engineering comments were proposed for the design, operation and management of the stabilized MSWI fly ash landfills.

Test Study on the Solidified Fly Ash

EXPERIMENTAL RESEARCH ON STABILIZATION OF RED CLAY WITH CEMENT AND FLYASH

Measurements of geotechnical properties of municipal solid waste incineration fly ash stabilized by chemical reagents

Study on Cement Solidification Technology in Treating with Fly Aash

Study of mechanization and mechanical property of cement mortar added with fly ash in case of early frost

A New Solidification Technology Of Municipal Solid Waste Incineration Fly Ash And Its Application In Asphalt Mixture

Research on Improving Cementitious Material Properties by Adding FineFly Ash

Experimental Study on Solidifying Contaminated Sediment via Waste Incineration Fly Ash

The Ratio Optimization and Strength Mechanism of Composite Cementitious Material with Low-Quality Fly Ash

Experimental Study on Effect of Content of Quicklime on Compressive Strength of Low-Calcium Fly Ash Mortar

Solidification of Municipal Solid Waste Incineration Fly Ash Through Co-Mechanical Treatment with Circulation Fluidized Bed Combustion Fly Ash

Microstructure of the concrete with high volume of fly ash-at the long-term age

Experimental study on the utilization of Fly ash solid waste in tunnel shotcrete materials

SOLIDIFICATION TREATMENT AND ENGINEERING APPLICATION OF A NEW SOLIDIFYING AGENT TOMAWI FLY ASH

The Influence of Fly Ash Addition on the Autogenous Shrinkage of High-Strength Concrete

Study on Mechanics Property Experiments of High Fly Ash Content Concrete

Study on the use of waste incineration fly ash for sediment solidification

Experimental Study on the Cracking Resistance at Early Ages of High Performance Concrete Added with Lithium Slag and Fly Ash

Experimental Study on Solidification/stabilization for Fly Ash from Waste Incineration

Test on the strength of the backfill fine sand mixture composed of cement-fly ash-cinder

Improvement of Surface Cementitious Properties of Low Activity Fly Ash