Abstract:Mechanical and electrical properties of carbon fiber (CF) and vertically aligned carbon nanotubes (CNTs) have been thoroughly investigated in previous studies. Growth of radially aligned CNTs on silicon oxide (SiO2) coated CF has recently been accomplished resulting in multiscale composite fiber (CNT/SiO2/CF). CNT/SiO2/CF offers promise as stress and strain sensors in CF reinforced composite materials. However, to date there have been no investigations of the electromechanical properties of CNT/SiO2/CF that would facilitate their usage as sensors in composite materials, which is the focus of this research. This study investigates fundamental mechanical and electrical properties of CF, SiO2/CF (SiO2 coated CF), and CNT/SiO2/CF during localized transverse compression at low loads (μN to mN) and small displacements (nm to a few μms). Force, strain, stiffness, and electrical resistance were monitored simultaneously during compression experiments. For CF, resistance decreased sharply upon compressive loading with hysteresis in both force and resistance being observed at low strain. For SiO2/CF, high resistance and negligible electrical conduction occurred, and the force-displacement curve was linear. CNT/SiO2/CF stiffness increased as force and strain increased and became comparable to that of CF at high strain (∼30%). Hysteresis in both force-displacement and resistance-displacement curves was observed with CNT/SiO2/CF, but was more evident as maximum strain increased and did not depend on strain rate. Force was higher and resistance was lower during compression as compared to decompression. Hysteretic energy loss is associated with internal friction between entangled CNTs. Van der Waals force between deformed and entangled CNTs hindered disentanglement, which reduced the number of electrical current paths and increased resistance during decompression. The results of this study provide new understanding of the mechanical and electrical behavior of CNT/SiO2/CF that will facilitate usage as stress and strain sensors in both stand-alone and composite materials applications.

Measuring the Stress in Field-Emitting Carbon Nanotubes

Observations of Carbon Nanotube Field Emission Failure in the Transmission Electron Microscope

Quantitative analysis of electron field-emission characteristics of individual carbon nanotubes: The importance of the tip structure

In-situ studies of electron field emission of single carbon nanotubes inside the TEM

A local field emission study of partially aligned carbon-nanotubes by AFM probe

Field Emission From Short And Stubby Vertically Aligned Carbon Nanotubes

Calculation of Field Enhancement Factor of the Carbon Nanotube Array

Field emission microscopy of carbon nanotube fibers: evaluating and interpreting spatial emission

Efficient Carbon Nanotube Field Emitter Using Electrospun Carbon Nanofibers as a Flexible Electrode

Carbon Nanotubes On Carbon Fabrics For Flexible Field Emitter Arrays

Lateral Field Emitters Fabricated Using Carbon Nanotubes

In Situ Characterization Of Individual Carbon Nanotube Field Emitters With Single Crystalline Cu Tips

Electron Field Emission Characteristics and Field Evaporation of a Single Carbon Nanotube.

Distance Sensitivity Characteristics Of Carbon Nanotubes Field Emission And Its Application In Sensors

Mechanical Fabrication of Carbon Nanotube Films and Their Field-Emission Properties

Mechanical and electrostatic properties of carbon nanotubes under tensile loading and electric field

Field emission from carbon nanotube fibers in varying anode-cathode gap with the consideration of contact resistance

Field emission from single multi-wall carbon nanotubes

Field Emission and Their Application in Ionization Gauge of CNTs-TiO2 Films

Field Evaporation of the End of a Carbon Nanotube

Electromechanical Characterization of Carbon Nanotubes Grown on Carbon Fiber