Abstract:Silicon carbon nitride thin films were deposited on Co-Cr alloy under varying deposition conditions such as sputtering power and the partial pressure ratio of N(2) to Ar by radio frequency and direct current magnetron sputtering techniques. The chemical bonding configurations, surface topography and hardness were characterized by means of X-ray photoelectron spectroscopy, atomic force microscopy and nano-indentation technique. The sputtering power exhibited important influence on the film composition, chemical bonding configurations and surface topography, the electro-negativity had primary effects on chemical bonding configurations at low sputtering power. A progressive densification of the film microstructure occurring with the carbon fraction was increased. The films prepared by RF magnetron sputtering, the relative content of the Si-N bond in the films increased with the sputtering power increased, and Si-C and Si-Si were easily detachable, and C-O, N-N and N-O on the film volatile by ion bombardment which takes place very frequently during the film formation process. With the increase of sputtering power, the films became smoother and with finer particle growth. The hardness varied between 6 GPa and 11.23 GPa depending on the partial pressure ratio of N(2) to Ar. The tribological characterization of Co-Cr alloy with Si-C-N coating sliding against UHMWPE counter-surface in fetal bovine serum, shows that the wear resistance of the Si-C-N coated Co-Cr alloy/UHMWPE sliding pair show much favourable improvement over that of uncoated Co-Cr alloy/UHMWPE sliding pair. This study is important for the development of advanced coatings with tailored mechanical and tribological properties. Crown Copyright (C) 2011 Published by Elsevier B.V. All rights reserved.

Surface Characteristics of Ni–Ga–Fe Sputtered Thin Films

Surface characteristics of Ni-Mn-Fe-Ga sputtered thin films

Structural and Magnetic Properties of NiZn–ferrite Thin Films Prepared by Radio Frequency Magnetron Sputtering

Surface morphology of ZnO buffer layer and its effects on the growth of GaN films on Si substrates by magnetron sputtering

Surface Morphology of Α-Sic Coatings Deposited by RF Magnetron Sputtering

Effects of sputtering conditions on the anisotropic magnetoresistance of Ni80Fe20 thin films

The Influence of Sputtering Argon Pressure on Lab6 Films Characetristics

Deposition and characterization for high-quality Ti–Ni–Cu thin films with higher Cu content

Studies of the Structure and Surface Roughness of AlN Thin Films

Growth, structural, and magnetic properties of iron nitride thin films deposited by dc magnetron sputtering

Growth condition dependence of structure and surface morphology of GaN films on (111)GaAs substrates prepared by reactive sputtering

Optimization of morphology and electrochemical characteristics of nickel film by sputtering pressure

Preparation and characterization of Ni–Mn–Ga high temperature shape memory alloy thin films using rf magnetron sputtering method

Surface Morphology and Dynamic Scaling in Growth of Iron Nitride Thin Films Deposited by Dc Magnetron Sputtering

The Effect of N2 Partial Pressure on the Properties of Nb–Si–N Films by RF Reactive Magnetron Sputtering

Synthesis, composition, surface roughness and mechanical properties of thin nitrogenated carbon films

Effect Of Sputtering Gas Pressure On Wear Resistance And Corrosion Resistance Of Niobium Films Prepared By Magnetron Sputtering Deposition

Effect of Sputtering Power on Structural, Cationic Distribution and Optical Properties of Mn2Zn0.25Ni0.75O4 Thin Films

Study on Crystallinity and Magnetic Properties of NiCuZn Ferrite Films Deposited by RF Sputtering

The characterization of fluorocarbon films on NiTi alloy by magnetron sputtering

The Structure, Surface Topography and Mechanical Properties of Si–C–N Films Fabricated by RF and DC Magnetron Sputtering