Abstract:Porous and composite piezoelectric ceramics are of interest for underwater ultrasonic transducers due to their improved voltage sensitivity and acoustic matching with water, compared with their dense counterparts. Commonly, these materials are fabricated by dice-and-fill of sintered blocks of polycrystalline piezoceramic, which results in a high volume of waste. The freeze-casting technique offers a low waste and scalable alternative to the dice-and-fill method to produce porous piezoceramics with highly orientated, anisometric pores. In this article, we have fabricated underwater ultrasonic transducers from freeze-cast lead zirconate titanate (PZT) with a range of porosities. The porous PZT samples were characterized in terms of their piezoelectric and dielectric properties before being encapsulated for acoustic performance testing in water. Off resonance, the on- axis receive sensitivity of the manufactured devices was approximately [Formula: see text]; the transmit voltage response (TVR) was in the range of approximately [Formula: see text] at 60 kHz to [Formula: see text] at 180 kHz. The most porous transducer devices (0.51, 0.43, and 0.33 pore fraction) exhibited primarily a thickness mode resonance, whereas the least porous transducers (0.29 pore fraction and dense benchmark) exhibited an undesired radial mode, which was observed as an additional resonant peak in the electrical impedance measurements and lateral off-axis lobes in the acoustic beampatterns. Our results show that the acoustic sensitivities and TVRs of the porous freeze-cast transducers are comparable to those of a dense pressed transducer. However, the freeze-cast transducers with porosity exceeding 0.30 pore fraction were shown to achieve an effective structure with aligned porosity that suppressed undesired radial mode resonances.

Composite Diaphragm Ultrasonic Transducers Employing Air-Gap Structure

Surface Wave Transducer for Ultrasonic Nondestructive Testing of Polymer Components

Research and Fabrication of High-Frequency Broadband and Omnidirectional Transmitting Transducer

Low insertion loss air-coupled ultrasonic transducer with parallel laminated piezoelectric structure

Broadband ultrasonic transducer based on nested composite structure with gradient acoustic impedance

Novel multi-layer-composites design for ultrasonic transducer applications

Design of Piezoelectric Ultrasonic Transducer Based on Doped PDMS

Fabrication and Modeling of Matching System for Air-Coupled Transducer

Ultra-wideband underwater acoustic transducer with a gradient impedance matching layer

Design simulation and analysis of deep-sea transducer

Broadband Gradient Impedance Matching Using an Acoustic Metamaterial for Ultrasonic Transducers

Study of polymer ultrasonic transducer and complex ultrasonic transducer with PZT/PVDF multi-layer structure

Ultrasonic Transducers Made From Freeze-Cast Porous Piezoceramics

Miniature Ultrasound Transducer Incorporating Sm-PMN-PT 1-3 Composite

Study of 1-3-2 type piezoelectric composite transducer array

Air-coupled ultrasonic transducer based on lead-free piezoceramics prepared by digital light processing 3D printing

Micromachined High Frequency PMN-PT/Epoxy 1&#x2013;3 Composite Ultrasonic Annular Arrays

Thin, flexible, and biocompatible medical ultrasound array transducer using a sol–gel composite spray technique

Concave Array Ultrasonic Transducer From Multilayer Piezoelectric Ceramic for Photoacoustic Imaging

Micromechanical Piezoelectric Micromachined Ultrasonic Transducer array package enhancement with integrated frontliners

Performance of transducers with segmented piezoelectric stacks using materials with high electromechanical coupling coefficient