Abstract:Ion contamination considerably influences the properties of geopolymers. This study investigated the effects of magnesium chloride (MgCl2) and magnesium sulfate (MgSO4) concentrations on the microstructure and properties of metakaolinite-based geopolymers with Si/Al ratios of 1.3 (adding NaOH) and 1.6 (adding NaOH and Na2SiO3). The chemical structures and compositions of as-obtained geopolymers formed through the alkali activation of kaolinite were characterized through X-ray diffraction, Fourier-transform infrared spectroscopy, and nuclear magnetic resonance (NMR) spectroscopy, while the microstructure was characterised via scanning electron microscopy and mercury intrusion porosimetry. The salt-free geopolymer with a Si/Al ratio of 1.3 exhibited a loose microstructure and hence poor 28-day compressive strength (9.4 MPa). The addition of magnesium salt to the geopolymer did not considerably influence its microstructure and mechanical properties. Comparatively, the geopolymer with a Si/Al ratio of 1.6 exhibited a compact microstructure and high 28-day compressive strength (43.0 MPa). The geopolymer compressive strength gradually decreased with increasing salt concentration. MgCl2 addition induced halite formation, increased pore diameter and pore volume, and reduced Si incorporated into the geopolymer matrix. In contrast, MgSO4 addition resulted in relatively less change in the pore diameter and pore volume and based on NMR result, more Si was incorporated into the geopolymer matrix. Thus, MgCl2 was more detrimental to the mechanical properties of the kaolinite-based geopolymers than MgSO4. Overall, the results indicate that salt contamination considerably affects the chemical compositions, microstructural characteristics, and compressive strength of metakaolinite-based geopolymers at high Si/Al ratio (adding NaOH and Na2SiO3) and those chlorine ions are more detrimental to the properties of metakaolinite-based geopolymer than sulfate ions.

Influence of Inorganic Salt Impurities on Seed Decomposition Rate in Sodium Aluminate Solutions

Effect of the Impurity Ions on the Crystallization of Urea Phosphate

Effect of Polyamidoamine on Surface Tension and Seed Precipitation in Sodium Aluminate Solution

Effect of impurity ions on the primary nucleation of ammonium alum precipitated from aqueous solution

Influences of Seeds on the Properties of Zeolite NaA Membranes on Alumina Hollow Fibers

A Kind Of Activity Seed Used For The Precipitation Of The Sodium-Aluminate Liquor

Preparation and characterisation of seed for simultaneous removal of sulphur and iron from sodium aluminate solution

Effect of Impurity Fe3+ on the Crystallization of Sodium Persulfate

Effects of Methanol on the Seeded Precipitation of Al(OH)3 from Potassium Aluminate Solution

Impurity Behavior in Aluminum Extraction by Low-Temperature Molten Salt Electrolysis

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

A single-step crystallization process to remove potassium from sodium aluminate solution

Effects of Al2(SO4)3 and K2SiO3 Impurities on the Crystallization of K2SO4 from Aqueous Solution

Influence of aluminate and silicate on selenate immobilization using alkaline-earth metal oxides and ferrous salt

An Experimental Study of Extracting Aluminum Hydroxide from High Caustic Sodium Aluminate Solution

Effect of Concentration of Aluminum Salts on Stability of Aluminosilicate Sand Stabilization Material

Influence of starting materials on plate-like alumina synthesized by molten salt method

Influence of Α-Alumina Seed on the Morphology of Grain Growth in Alumina Ceramics from Bayer Aluminum Hydroxide

Influence of NaCl and Osmotic PEG4000 Stress on Seed Germination of Medicago sativa

The effects of salinity stress on Amorpha fruticosa Linn. seed germination, physiological and biochemical mechanisms

Effect of magnesium salt contamination on the microstructures and properties of metakaolinite-based geopolymer: the role of MgCl2 and MgSO4