Abstract:The blast pressure acting on the borehole wall is the basis of the dynamic analysis of rock blasting. The history of blast-induced borehole wall pressure (BWP) is difficult to measure owing to the complex interaction between the blasting load and the borehole wall, and the limitations of the general test system. In this work, the complete history of BWP under air-deck charge was measured for the first time, and the stress-response process was analyzed. PVDF (polyvinylidene fluoride) gages and a charge mode for the test circuit were employed. To improve the testing accuracy, the matching relationships among the parallel capacitor, the equivalent capacitance of PVDF gages, and the parasitic capacitance of the coaxial cable were effectively addressed. The experimental data within the span of 0–0.65 m from the explosive cartridge center show that there are two obvious peaks in the complete history of BWP, the first is a μs-level air shockwave load, followed by a ms-level explosion gas load. The peak of BWP is dominated by the peak of explosion gas ( P g ) within the scope of about 0–0.35 m from the explosive cartridge center, while is mainly determined by the peak of air shockwave ( P s ) in a farther range. The specific impulse distribution suggests that the explosion energy is mainly consumed in the area within the range of about 0–0.25 m from the explosive cartridge center. The strain rate in the borehole wall induced by air shockwave demonstrates a dynamic response (range of 131.9 ~ 2922.6 s −1 ), while indicating a quasi-dynamic loading (range of 0.1 ~ 2.1 s −1 ) when induced by the explosion gas. The findings contribute to expanding the understanding of the stress characteristics of the air shock wave and explosion gas and provide accurate initial loads for numerical simulation related to rock blasting of non-fluid–solid coupling.

The Research on Dynamic Characters of Transducers for Blast Wave Measurement

Study on measurement technology of dynamics characteristics of typical tubes for pressure measurements

NON-CONTACT MEASUREMENT TECHNIQUE FOR DYNAMIC RADIAL DEFORMATION OF EXPLOSION CONTAINMENT VESSELS

Perforating Gun Detonation Monitoring System Based on Tubing Vibration

High-Impact Dynamic Loading Method for Calibration of Triaxial Acceleration Sensors

Research on Transmission Performance of a Surface Acoustic Wave Sensing System Used in Manufacturing Environment Monitoring

New concept of transient calibration for acoustic transducers

A Device for Measuring Propagation Time of Ultrasonic Wave

Research on the Shock Wave Overpressure Peak Measurement Method Based on Equilateral Ternary Array

Experimental Research On Transient Electromagnetic Wave Transmission Characteristics In Single-Hole

Research and Fabrication of High-Frequency Broadband and Omnidirectional Transmitting Transducer

Modeling of Ammunition Dynamic Pressure Measurement Chain in Ballistic Tests

Experimental Study of Blast-Induced Vibration Characteristics Based on the Delay-Time Errors of Detonator

Research on the Equivalent Impact Test Method for Different Pulse Widths Based on Micro-Electro-Mechanical System Devices

A Transfer Function Approach to Shock Duration Compensation for Laboratory Evaluation of Ultra-High-G Vacuum-Packaged MEMS Accelerometers

Research on thermal protection of piezoelectric pressure sensor for shock wave pressure measurement in explosion field

Measurement and Stress Response Analysis of Complete History of Blast-Induced Wall Pressure for Boreholes: A Case with Air-Deck Charge

Non contact shock-wave velocity testing based on optical-fiber interference system

Investigation on Vibration Characteristics of Thin-Walled Steel Structures under Shock Waves

Numerical Simulation of the Effect of Blast Shock Wave on Target Plate

A Planar Fabricated 1-3 Composite Ultrasonic Transducer to Determine the Dynamic Response of Microstructures