Abstract:The pneumatic transport of granular material is a common operation frequently employed to transport solid particles from one location to another. It is well established in the literature that different flow regimes can arise in such transportation processes depending on the system geometry and operating conditions used. In this study, the pneumatic transports of solid particles in both vertical and horizontal conveying lines were studied numerically using the discrete element method coupled with computational fluid dynamics. The simulation outputs corresponded well with reported experimental observations in terms of the different flow regimes obtained at different operating conditions. In the vertical pneumatic conveying simulations, two different flow patterns corresponding to the experimentally observed dispersed flow and plug flow regimes were obtained at different gas velocities and solid concentrations. Similarly, the homogeneous flow, stratified flow, moving dunes, and slug flow regimes previously reported to occur in horizontal pneumatic conveying were also reproduced computationally in this study. Solid concentration profiles obtained by spatial averaging along the length of the pipe showed a symmetrical but non-unifonn distribution for dispersed flow and an almost flat distribution for plug flow in vertical pneumatic conveying. The profile for stratified flow in horizontal pneumatic conveying showed higher solid concentration near the bottom wall due to the effects of gravitational settling, while that for slug flow was flat. Hysteresis in solid flow rates was observed in vertical pneumatic conveying near the point where transition between the dispersed and plug flow regimes was expected to occur. Solid flow rates were also found to be more sensitive towards the coefficient of friction than the coefficient of restitution of particles and the pipe walls in a sensitivity analysis study of these parameters. (c) 2005 American Institute of Chemical Engineers AIChE J, 52: 496-509, 2006 Keywords: numerical simulation, discrete element method, computationalfluid dynamics, pneumatic conveying, flow regimes

Discrete element simulation for pneumatic conveying of granular material

The simulations of pneumatic conveying

Pneumatic transport of granular materials with electrostatic effects

Micromechanic Modeling and Analysis of the Flow Regimes in Horizontal Pneumatic Conveying

Numerical simulations on the flow regime characteristics of horizontal pneumatic conveying using CFD-DEM

ELECTROSTATIC EFFECTS IN PNEUMATIC TRANSPORT OF GRANULAR MATERIALS

Computational Investigation of Horizontal Slug Flow in Pneumatic Conveying

Computational Study of Flow Regimes in Vertical Pneumatic Conveying

Numerical Study of Horizontal Pneumatic Conveying: Effect of Material Properties

CFD–DEM Simulation of Pneumatic Conveying in a Horizontal Channel

Numerical Study of the Influence of Particle Friction on Horizontal Pneumatic Conveying

Numerical simulation of dense-phase pneumatic conveying in vertical pipe for gasifier

Simulation of Gas-Solid Flow in Vertical Pipe by Hard-Sphere Model

Numerical Simulation of Flow Patterns in Dense Pneumatic Conveying at Different Superficial Gas Velocities

Computational investigation of particle flow characteristics in pressurised dense phase pneumatic conveying systems

Competing Flow of Dissimilar Granular Materials in Air

Gas–Solid Flow and Energy Dissipation in Inclined Pneumatic Conveying

Numerical Simulation of Dense-Phase Pneumatic Transport of Powder in Horizontal Pipes

DEM/CFD Modelling of the Deposition of Dilute Granular Systems in a Vertical Container

Numerical Simulation on Gas-Solid Two-Phase Flow in Horizontal Pneumatic Conveying Pipe Based on DPM Model

Simulation of Flow Regimes of Particles in a Horizontal Pipe