EFFECT OF PHOTOCATALYTIC DEGRADATION OF GASEOUS DIMETHYL SULFIDE UNDER UV-LED LAMPS IRRADIATION

Jing LIU,Yuancan DAI,Zimeng WANG,Shicheng ZHANG,Weiyang DONG,Jianmin CHEN
IF: 4.236
2010-01-01
Environmental Chemistry
Abstract:Photocatalytic degradation of low concentration(8.3mg·m-3) gaseous dimethyl sulfide over Degussa P25-TiO2 films under UV-LED lamps irradiation in a homemade plate-type reactor was investigated.Effects of catalyst loading,light intensity,temperature,gas flow rate and relative humidity on the removal efficiency and reaction rate were discussed in detail.Enhancement of catalyst loading,light intensity and decrease of gas flow rate were effective methods to improve the removal efficiency.DMS removal efficiency increased with the enhancement of catalyst loading from 5.0 to 36.0μg·cm-2 and the maximum of 97.6% was achieved.Under the present condition,room temperature of 21.6℃ and ambient relative humidity of 47.5% were appropriate to the photocatalytic degradation of DMS than lower temperature of 12.1℃ and lower RH of 10.9%—29.8%.We noted that DMS reaction rate was affected significantly by gas flow rate.It increased sharply at low flow rate(3.4×10-7m3·s-1,mass transfer controlling stage) and changed slightly at the interim period(3.4×10-7-6.8×10-7m3·s-1,transitional stage) then reached a plateau at high flow rate(6.8×10-7m3·s-1,chemical reaction controlling stage).
What problem does this paper attempt to address?