Abstract:Interface adhesion between cast iron substrate and oxide layer formed during dry unidirectional sliding wear was studied by using thermo-mechanically processed 4.8Ni–1.5Cr cast iron. The purpose of the present work is to reveal the difference of the adhesion behaviour between martensitic matrix with a higher hardness and austenitic matrix with low hardness. The 4.8Ni–1.5Cr alloy was sandwiched as a middle layer with low carbon steel as outer layers and thermo-mechanically processed via (1) hot rolling (HR), (2) hot rolling and heat treatment (HT), and (3) hot rolling, heat treatment and hot compression (HC), respectively. The applied normal loads were 20 and 40N, and the sliding speeds were 45 and 78mm/s in sliding wear test. The durations of the wear test were 2 and 7min, respectively for different testing rounds. It was found that the wear after running-in was always mild under the conditions of 20N and 45mm/s or 20N and 78mm/s for all the tested samples. Prior to the transition into mild oxidational wear, negative displacements of pins were observed for HT and HC samples when the applied load was raised to 40N at the sliding speed of 78mm/s. No similar response was observed for HR sample under the same testing condition. The possible mechanisms for the negative displacement of pin in the test are discussed in terms of the microstructure and phases of the testing samples. The effect of the hardness of the substrate on the growth and integrity of the oxide film formed during the sliding and the interface adhesion between the oxide film and substrate are also discussed.

Influence of H13 steel unit on wear behavior of vermicular cast iron

The Thermal Fatigue Resistance of Vermicular Cast Iron Coupling with H13 Steel Units by Cast-in Process

Bio-inspired Wearable Characteristic Surface: Wear Behavior of Cast Iron with Biomimetic Units Processed by Laser

Effect of the Microhardness Difference Between Base Metal and Bionic Coupling Unit on Wear Resistance of Gray Cast Iron

Study on Quantitative Relation Between Characteristics of Striature Bionic Coupling Unit and Wear Resistance of Gray Cast Iron

Friction and Wear Properties of Cast-iron Material with Bionic Non-smooth Surface under Normal Temperature

Influence of Cycle Temperature on the Wear Resistance of Vermicular Iron Derivatized with Bionic Surfaces

Influence of Multiple Bionic Unit Coupling on Sliding Wear of Laser-Processed Gray Cast Iron

Effect of bionic coupling units׳ forms on wear resistance of gray cast iron under dry linear reciprocating sliding condition

The investigation on friction and wear properties of cast iron matrix surface compact vanadium carbide layer

Wear properties of H13 with micron scale and nano scale grains bionic units processed by laser remelting

Study on Friction and Wear Performance of Bionic Coupling Surface Moving Pair of 45 Steel

Friction and Wear Behaviors of Compacted Graphite Iron with Different Biomimetic Units Fabricated by Laser Cladding

Processing and Wear Resistance of Carbon-Steel/High-Cr-Cast-Iron Bimetal Composite

Effects of Different Bionic Units Coupling on the Sliding Wear of Gray Cast Iron

Anti-wear properties on 20CrMnTi steel surfaces with biomimetic non-smooth units

Lubricating Property of Cast Iron Combined with Two-Scale Unit Structure by Biomimetic Laser Treatment

Influence of Varying Forms of Bionic Units on Repairing Remaining Quenching Surface of Gray Cast Iron

Study on the Response and Wear Property of Die Steels with Varying Compositions to Laser Remelting Bionic Treatment

Effect of Medium on Friction and Wear Properties of Compacted Graphite Cast Iron Processed by Biomimetic Coupling Laser Remelting Process

Interface Adhesion During Sliding Wear in Cast Iron after Hot Deformation