Abstract:Oil shale is an important unconventional energy and has enormous reserves in the world. However, the high moisture content impedes its utilization in the restoration and combustion process. This paper explores experimental and numerical studies on the drying performance of the Liu Shu River oil shale in a pneumatic conveying dryer (4.8 cm ID, 1.8 m high). The experiments were carried out under the different operation conditions. The 3-D modeling was done with a computational fluid dynamics package, in which the gas phase is modeled as a continuum using Euler approach, and the particle phase is modeled by a discrete phase model with a Lagrangian approach. The effects of inlet air velocity, particle size, solid mass flow rate, and inlet air temperature on the drying performance of oil shale particles are investigated. It is found that the simulated values are in good agreement with experimental data. The developed model of Nu = 0.035Re(p)(1.15)Pr(0.333) is thus suitable to describe the oil shale pneumatic drying process. Generally, it is concluded that the moisture evaporation occurs mainly at the constant rate drying stage in the pneumatic drying process due to very short residence time. The drying rate increases as the inlet air velocity and temperture increase, while increasing the particle size or the solid mass flow rate decreases the drying rate. It is the breakthrough to improve the drying efficiency by increasing the slip velocity and extending pariticle residence time in the dryer. Gas temperature and particle size have the significant influence on degree of particle drying. But the mass flow rate and gas velocity are the important parameters for the energy efficiency in the drying process.

Numerical Simulation and Analysis of Pneumatic Drying on Straw Fuel

Numerical Simulation and Experimental Research of Pneumatic Drying on Biomass Fuel

The simulation and experimental analysis for pneumatic drying of biomass stalk.

The Experimental Investigation and Numerical Simulation for Pneumatic Drying of Stalk

NUMERICAL SIMULATION FOR DRYING PROCESS OF GAS FLOW CONTAINING HUMID COAL ASH PARTICLES

The simulation analysis and experiment of drying thin-layer radish strips

Numerical Simulation and Analysis of Drying Process of Paper in Dryer Section

Numerical Simulation and Test Study on Particulate Materials Mass Transfer

Numerical Simulation and Test of Particulate Materials Heat and Mass Transfer

Numerical Simulation and Experimental Validation of Oil Shale Drying in Pneumatic Conveying Dryer

Two-Dimensional Mathematical Modeling of Heat and Mass Transfer in Fluidized-Bed Drying of Porous Material

RESEARCH ON DRYING MECHANISM OF HEAT AND MASS TRANSFER OF STALK (Ⅱ)——KINETICS NUMERICAL SIMULATION

Numerical Simulation of Combustion in a Straw-fired Boiler

Numerical simulation on superheated steam fluidized bed drying: II. Experiments and numerical simulation

Mathematical modeling of combustion in a grate-fired boiler burning straw and effect of operating conditions under air- and oxygen-enriched atmospheres

Experimental and Numerical Analysis of Oil Shale Drying in Fluidized Bed

SIMULATION OF BIOMASS DRYING IN A DIRECT CONTACT ROTARY DRYER

Mathematical Model and Numerical Simulation of Continuous Drying Tower

Numerical simulation of single lignite particle drying process in high temperature flue gas

Simulation Investigation of Drying Characteristics of Wet Filamentous Biomass Particles in a Rotary Kiln

Numerical Simulation and Analysis of Effect of Injection Volume on Biomass Particle Cyclone Venturi Dryer