Abstract:In this paper, we analyze the autothermal reforming (ATR) of methane through Gibbs energy minimization and entropy maximization methods to analyze isothermic and adiabatic systems, respectively. The software GAMS® 23.9 and the CONOPT3 solver were used to conduct the simulations and thermodynamic analyses in order to determine the equilibrium compositions and equilibrium temperatures of this system. Simulations were performed covering different pressures in the range of 1 to 10 atm, temperatures between 873 and 1073 K, steam/methane ratio was varied in the range of 1.0/1.0 and 2.0/1.0 and oxygen/methane ratios in the feed stream, in the range of 0.5/1.0 to 2.0/1.0. The effect of using pure oxygen or air as oxidizer agent to perform the reaction was also studied. The simulations were carried out in order to maintain the same molar proportions of oxygen as in the simulated cases considering pure oxygen in the reactor feed. The results showed that the formation of hydrogen and synthesis gas increased with temperature, average composition of 71.9% and 56.0% using air and O2, respectively. These results are observed at low molar oxygen ratios (O2/CH4 = 0.5) in the feed. Higher pressures reduced the production of hydrogen and synthesis gas produced during ATR of methane. In general, reductions on the order of 19.7% using O2 and 14.0% using air were observed. It was also verified that the process has autothermicity in all conditions tested and the use of air in relation to pure oxygen favored the compounds of interest, mainly in conditions of higher pressure (10 atm). The mean reductions with increasing temperature in the percentage increase of H2 and syngas using air under 1.5 and 10 atm, at the different O2/CH4 ratios, were 5.3%, 13.8% and 16.5%, respectively. In the same order, these values with the increase of oxygen were 3.6%, 6.4% and 9.1%. The better conditions for the reaction include high temperatures, low pressures and low O2/CH4 ratios, a region in which there is no swelling in terms of the oxygen source used. In addition, with the introduction of air, the final temperature of the system was reduced by 5%, which can help to reduce the negative impacts of high temperatures in reactors during ATR reactions.

Characteristic Study of Micro-channel Auto-thermal Reforming of Methane with Ni/Rh Catalysts

Characterization of CH4-CO2-O2 Diffusion Flames Near Autothermal Reforming Condition

The Effects of CO2/CH4 Ratio on Soot Formation for Autothermal Reforming of Methane at Elevated Pressure

A comparative study of Rh and Ni coated microchannel reactor for steam methane reforming using CFD with detailed chemistry

Autothermal reforming of methane on rhodium catalysts: Microkinetic analysis for model reduction

Hydrogen Production Of A Heavy Hydrocarbon Fuel Autothermal Reformer On Nio-Rh Based Monolithic Catalysts

Catalytic Performance of Ni Catalyst for Steam Methane Reforming in a Micro-Channel Reactor at High Pressure

Autothermal Reforming of Methane: A Thermodynamic Study on the Use of Air and Pure Oxygen as Oxidizing Agents in Isothermal and Adiabatic Systems

The Intrinsic Kinetics of Methane Steam Reforming over a Nickel-Based Catalyst in a Micro Fluidized Bed Reaction System

A Micro-Reactor with Micro-Pin-fin Arrays for Hydrogen Production Via Methanol Steam Reforming

Improved Catalytic Performance of Ni Catalysts for Steam Methane Reforming in a Micro-Channel Reactor

Methane Autothermal Reforming with CO2 and O2 to Synthesis Gas at the Boundary Between Ni and ZrO2

Steam reforming of methane over Ni catalyst in micro-channel reactor

Mechanistic and Microkinetic Insights into the Stability and Activity of Ni3In Catalyst for Dry Methane Reforming

Characteristic Investigation on the Methanol Steam Reforming Microchannel Reactor with the Novel Catalytic Combustion Self-Heating Structure for Hydrogen Production

Mechanistic and microkinetic insights into the stability and activity of Ni 3 In catalyst for dry methane reforming

Production of Syngas Via Autothermal Reforming of Methane in a Fluidized-Bed Reactor over the Combined CeO2–ZrO2/SiO2 Supported Ni Catalysts

An Annular Reactor for Direct Methane Autothermal Reforming

STEAM REFORMING OF METHANE IN CATALYTIC MICROREACTORS FOR HYDROGEN PRODUCTION

Tri-reforming of methane over Ni/ZrO2 catalyst derived from Zr-MOF for the production of synthesis gas

Milliseconds Steam Reforming of Methane Using Rh/MgO/γ-Al2O3 Catalyst