Abstract:A novel technical solution about helically coiled tube-in-tube (HCTT) heat exchanger with double cooling source is proposed to obtain regeneratively cooled air for advance aeroengine. 54 simulation runs are performed according the Box-Behnken design table, in which the effect of geometrical and operating parameters on performance of heat exchanger are well considered. Grid independence was carefully carried out referring to ASME V&V 20–2009. The simulation model is validated based on comparison with available experimental data and analysis of flow pattern. The performance of the HCTT heat exchanger i.e. entropy generation number Ne, absorption heat ratio of the inner tube η, and out temperature of the regeneratively cooled air Ta,out were evaluated using Response Surface Methodology. The significance of each term in regression model has been checked by analysis of variance. The results shows that all the design variables are significant for predicting Ne, η, and Ta,out, except non-dimensional coil pitch λ for finding η; the regression models have a good prediction performance; outer tube curvature ratio (δo) is the most significant structure parameter affecting Ne and Ta,out, while inner tube curvature ratio (δi) is the most significant linear term for predicting η, indicating that δo and δi are key structure parameters. It also shows that heat transfer characteristics of the HCTT heat exchanger are complicated engineering problem subjected to multi factors interaction. For instance, total number of terms in model for predicting η reaches to 18, including 5 linear terms, 10 interaction terms along with 3 square terms. The influences of all interaction terms on Ne, η, and Ta,out were displayed using 3D surface graph, the effect rule of interaction terms were discussed in details. Desirability function approach was employed to conduct multi-objective optimization for goals of Ta,out = 630 K, and minimum Ne and η. The optimum values of design variable were obtained. This method possesses practical significances for prediction and optimization of HCTT heat exchanger.

Optimal Analysis of Flow Parameters for Marine Gas Turbine Intercooler

Optimal Design and Performance Analysis of Marine Gas Turbine Intercooler

Research on the Flow Path Design Method of Axial Flow Compressor of Gas Turbine

Numerical simulation of intercooler flow path for marine gas turbine

Application of Primary Surface Heat Exchanger in Intercooler System of Marine Gas Turbine

Numerical Simulation of Heat Transfer and Fluid Flow on Marine Gas Turbine Intercooler

Optimization of exhaust ejector system for marine gas turbine enclosure cooling: Computational fluid dynamics analysis and parameter optimization

Methodology of design and analysis on the thermal hydraulic performance of the cross-flow printed circuit heat exchanger

Thermal Design and Optimization of Plate-Fin Heat Exchangers Based Global Sensitivity Analysis and NSGA-II

Genetic Algorithm Based Design and Optimization of an Outer-Fins and Inner-Fins Tube Heat Exchanger

Numerical Study And Optimization Of Corrugation Height And Angle Of Attack Of Vortex Generator In The Wavy Fin-And-Tube Heat Exchanger

Optimal Design Method of Fins in Automotive Oil Cooler Based on the Thermal-Hydraulic Performances

STUDY ON COOLING AIR ALLOCATION AND EXPANDER POWER CALCULATION OF LARGE SCALE GAS TURBINE

Conceptual design of a two-pass cross-flow aeroengine intercooler

Optimization Design and Comparative Analysis of Enhanced Heat Transfer and Anti-Vibration Performance of Twisted-Elliptic-Tube Heat Exchanger: A Case Study

NUMERICAL STUDY OF DIFFERENTIAL AND OPTIMAL DESIGN FOR MULTI-STREAM PLATE-FIN HEAT EXCHANGER

Simulation and Optimization of CO2 Fin-tube Gas Cooler

Analysis, prediction and multi-objective optimization of helically coiled tube-in-tube heat exchanger with double cooling source using RSM

Research on the Optimization of a Diesel Engine Intercooler Structure Based on Numerical Simulation

Performance Evaluation of an Inter-Cooler for Turbo-Charger System of Internal Combustion Engine

Through-Flow Calculation with A Cooling Model for Cooled Turbines