Abstract:This article studies the fundamental problem of separating two adhesive elastic fibers based on numerical simulation employing a recently developed finite element model for molecular interactions between curved slender fibers. Specifically, it covers the two-sided peeling and pull-off process starting from fibers contacting along its entire length to fully separated fibers including all intermediate configurations and the well-known physical instability of snapping into contact and snapping free. We analyze the resulting force-displacement curve showing a rich and highly nonlinear system behavior arising from the interplay of adhesion, mechanical contact interaction and structural resistance against (axial, shear and bending) deformation. While similar to one-sided peeling studies from the literature, a distinct initiation and peeling phase can be observed, the two-sided peeling setup considered in the present work reveals the extended final pull-off stage as third characteristic phase. Moreover, the influence of different material and interaction parameters such as Young's modulus as well as type (electrostatic or van der Waals) and strength of adhesion is critically studied. Most importantly, it is found that the maximum force occurs in the pull-off phase for electrostatic attraction, but in the initiation phase for van der Waals adhesion. In addition to the physical system behavior, the most important numerical aspects required to simulate this challenging computational problem in a robust and accurate manner are discussed. Thus, besides the insights gained into the considered two-fiber system, this study provides a proof of concept facilitating the application of the employed model to larger and increasingly complex systems of slender fibers.

Some Further Considerations of the Theory of Fibre Debonding and Pull-out from an Elastic Matrix. Part 2: Non-constant Interfacial Frictional Shear Stress

Keynote: EXPLICIT MODELLING OF FIBRE PULLOUT IN CEMENTITIOUS COMPOSITES

Analysis of energy release rate for interfacial debonding in fiber pull-out by using stress functions

Pullout Strength of Graphene and Carbon Nanotube/epoxy Composites

Coulomb frictional interfacial stresstransfer in fiber pull-out

Properties of Frictional Bridging in Fiber Pull-out for Fiber-Reinforced Composites

Dynamic Tensile Behavior of Fiber Reinforced Materials Based on Fiber Layering Modeling

Simulation and Analysis of Single Fibre Pull-out Test with FEM

A cohesive zone model for the elevated temperature interfacial debonding and frictional sliding behavior

Frictional pull-out work capacity of macro-SSF in concrete composites and evaluation of matrix deterioration due to kinematic fiber-end-slip after full-debonding point

Simulation and Analysis of Single Fiber Pull-out Tests Through ANSYS and VC++

A New Model of Interfacial Adhesive Strength of Fiber-Reinforced Polymeric Composites Upon Consideration of Cohesive Force

Adhesion Model of Side Contact for an Extensible Elastic Fiber

Influence of Interfacial Microstructure on Pullout Behavior and Failure Mechanism of Steel Fibers Embedded in Cement-Based Materials

Effect of Shear Resistance on Flexural Debonding Load-Carrying Capacity of RC Beams Strengthened with Externally Bonded FRP Composites

A novel approach based on stress-impedance effect to assess the interfacial properties in fiber-reinforced composites

A cohesive zone model incorporating a Coulomb friction law for fiber-reinforced composites

Interface Debonding Criteria in SiC Fiber-Reinforced Composites

An experimental and numerical study on the age depended bond-slip behavior between nano-silica modified carbon fibers and cementitious matrices

Investigation of the Peeling and Pull-off Behavior of Adhesive Elastic Fibers via a Novel Computational Beam Interaction Model

A Dynamic Meso-Scale Model of the Pullout Behavior for Non-Straight Fibers and Corresponding DEM3 Simulation