Abstract:The DarkSHINE experiment aims to search for dark photons by measuring the energy loss of the electrons recoiled from fixed-target. Its electromagnetic calorimeter is primarily responsible for accurately reconstructing the energy of the recoil electrons and bremsstrahlung photons. The performance of the electromagnetic calorimeter is crucial, as its energy measurement precision directly determines the sensitivity to the search for dark photons. The DarkSHINE electromagnetic calorimeter uses LYSO crystals to form a fully absorptive electromagnetic calorimeter. It utilizes SiPMs to detect scintillation light in the crystals, and its readout electronics system deduces the deposited energy in the crystals by measuring the number of photoelectric signals generated by the SiPMs. The DarkSHINE electromagnetic calorimeter aims to operate at an event rate of 1-10 MHz, detecting energies ranging from 1 MeV to 1 GeV. To meet the requirements of high energy measurement precision, high event rate, and large dynamic range, we have researched and designed a readout electronics system based on dual-channel high-speed ADCs and a customized DAQ. The front-end amplification part of this system uses low-noise trans-impedance amplifiers to achieve high-precision waveform amplification. It successfully achieves a dynamic range up to a thousandfold through a double-gain readout scheme. The digital part uses 1 GSPS high-speed ADCs to achieve non-dead-time, high-precision waveform digitization. The DAQ part uses JESD204B high-speed serial protocol to read out the signal from ADC, and transmit it to PC software for processing and storage. Test results show a signal-to-noise ratio greater than 66 dBFS and an ENOB greater than 10.6 bits. Energy spectra measurements have been conducted using LYSO crystals and SiPMs, and an energy resolution of 5.96% at the 2.6 MeV gamma peak of Th-232 has been achieved.

The Design of High Speed ADC Module of the Under Ground Dark Matter Experiment

FADC electronics design for HPGe detector

Design of a triggerless readout electronics system for CDEX-50

Design of a high-speed multi-channel data acquisition system based on FPGA

Design of High-speed readout electronics for the DarkSHINE electromagnetic calorimeter

8-Channel 14-Bit 125mhz FADC Electronics with 1G Ethernet Readout Based on ZYNQ for HPGe Detector

Research on high-speed ADC test and evaluation system

Design of 1Gsps high-speed data acquisition card

Preliminary Design of Pulse Digitalization and Readout Electronics for CDEX-10

Prototype of Pulse Digitizer and Readout Electronics for CDEX-10 in CJPL

High Performance Readout Module Based on ZYNQ with Giga Ethernet

Design and Implementation of High Performance DAQ System for IRFPA Testing

Quantitative Analysis of the High Speed and High Precision Waveform Digital System for Jinping Neutrino Experiment

Development of Cryogenic CMOS Readout ASICs for the Point-Contact HPGe Detectors for Dark Matter Search and Neutrino Experiments

A 1.6-Gsps High-Resolution Waveform Digitizer Based on a Time-Interleaved Technique

Design and application of readout module ZYNQBee with Gigabit Ethernet interface based on ZYNQ

Preliminary Design of Readout Electronics for CDEX-10 in CJPL

The design of a time-interleaved analog-digital conversion modulator based on FPGA-TDC for PET application

The Prototype Design of Integrated Base for PMT with Pulse Digitalization and Readout Electronics

The Data Acquisition System of the LZ Dark Matter Detector: FADR

The DAQ Ssystem and the Experiment Setup of the PMT Test System in CDEX-10