Abstract:Crack behavior of aluminum alloy 2A12-T4 is investigated experimentally and numerically using cruciform specimens subjected to in-plane biaxial loadings applied in horizontal (x axis) and vertical (y axis) directions. Different cruciform configuration plans, with variant sizes of slots in loading arms and different transitional fillet radius between adjacent arms, are analyzed by means of FEM to confirm a final specimen geometry with relative uniform stress distribution in its central area. The tests for fatigue crack growth behavior under cyclic biaxial sinusoidal loadings with phase differences of 0 degrees or 60 degrees between two orthogonal fatigue loads are conducted by using a biaxial fatigue test system. The biaxial load ratio, P-max(x)/P-max(y), varies from -0.5 to 1.0. Initial central cracks are inclining in angles of 0 degrees, 45 degrees and 60 degrees to x-axis. Crack growth path and lives are obtained. It is observed that the crack growth behavior under biaxial loading differs from that with only uniaxial loading. A widely accepted fatigue crack growth model, which combines Paris equation, maximum tangential stress (MTS) criterion and an equivalent stress intensity factor (SIF) proposed by Tanaka, is used for mixed mode-I/II crack subjected biaxial loading. The combined model is evaluated by the SIFs analysis based on analytical and numerical solution. The mixed mode SIFs are calculated based on finite element analysis with mesh updating. The simulated crack growth path and growth lives correlate well with the experiments in most cases. Both the experiments and the simulations demonstrate that the tensile load parallel to crack path behaves as the retarder to the crack growth, and the compressive load parallel to crack path behaves as the promoter to the crack growth. It is found that equivalent SIF used in the model overestimates the effect of mode II SIF on the fatigue crack growth rate by Paris equation. It is questionable to use the combined model for the cases with asynchronous biaxial loadings or those leading to crack surface contact.

Fatigue Growth Prediction of Center Slant Crack in Rectangular Plate

A Boundary Element Modeling of Fatigue Crack Growth in a Plane Elastic Plate

Multiple Crack Fatigue Growth Modeling by Displacement Discontinuity Method with Crack-Tip Elements

Fatigue Growth Modeling of Cracks Emanating from a Circular Hole in Infinite Plate

Fatigue paths simulation of a center slant crack in cracked brazilian disk by bem

An X-FEM Approach for Simulation of 3-D Multiple Fatigue Cracks and Application to Double Surface Crack Problems

INTERACTION OF THREE PARALLEL CRACKS IN RECTANGULAR PLATE UNDER CYCLIC LOADS

A Simple And Efficient X-Fem Approach For Non-Planar Fatigue Crack Propagation

Fatigue Life Prediction of Cracked Stiffened Plate Using the Improved Fatigue Crack Growth Rate Model

Numerical Simulation of the Multiple 3D Crack Propagation from the Countersunk Fastener Holes

Mixed-mode Fatigue Crack Growth Prediction in Biaxially Stretched Sheets

A New Approach to Predicting Fatigue Crack Propagation

Interaction among Three Parallel Cracks under a Uniaxial Cyclic Load: A Boundary Element Modelling

Fatigue Crack Behaviors under Asynchronous Biaxial Loading

A New Cohesive Crack Tip Symplectic Analytical Singular Element Involving Plastic Zone Length for Fatigue Crack Growth Prediction under Variable Amplitude Cyclic Loading

Prediction Of Short Fatigue Crack-Growth In Compressive Residual-Stress Field

Investigation of Fatigue Growth Behavior of an Inclined Crack in Aluminum Alloy Plate

Numerical prediction based on XFEM for mixed-mode crack growth path and fatigue life under cyclic overload

Prediction of Low Cycle Fatigue Crack Growth under Mixed-mode Loading Conditions Using Cohesive Zone Models

Fatigue Growth Analysis of an Inclined Crack under Uniaxial Cyclic Loading in Materials with Different Yield Strengths in Tension and Compression

An Approach for Fatigue Life Prediction