Abstract:The tensile strength of concrete material increases with the strain rate. The dynamic tensile strength of concrete material is usually obtained by conducting laboratory tests such as direct tensile test, spall test or splitting test (Brazilian test). It is commonly agreed now that the DIF obtained from dynamic impact test is affected by lateral inertia confinement. Therefore, those derived directly from testing data do not necessarily reflect the true dynamic material properties. The influence of the lateral inertia confinement, however, is not straightforward to be quantified in laboratory tests. Moreover, concrete is a heterogeneous material with different components, but is conventionally assumed to be homogeneous, i.e. cement mortar only, in most previous experimental or numerical studies. The aggregates in concrete material are usually neglected owing to testing limitation and numerical simplification. In the present study, a mesoscale concrete material model consisting of cement mortar, aggregates and interfacial transition zone (ITZ) is developed to simulate direct tensile tests and to study the influences of the lateral inertia confinement and heterogeneity on tensile strength of concrete material with respect to strain rates between 1/s and 150/s. The commercial software AUTODYN with user provided subroutines is used to perform the numerical simulations of SHPB tests. The model is verified by testing data obtained by others. Numerical simulation results indicate that the lateral inertia confinement contributes to the dynamic increase factor (DIF) of concrete material tensile strength. The lateral inertia confinement effect is specimen size and strain rate dependent. Based on the numerical results, discussions on the relative contributions from the lateral inertia confinement and the material strain rate effect on DIF of concrete material tensile strength are made. Empirical relations are proposed to remove the influence of the lateral inertia confinement in dynamic impact tests on dynamic concrete material strength. The effect of aggregates inside the concrete specimen on its dynamic strength is also investigated. The results demonstrate that it is very important to include aggregates in experimental and numerical studies of concrete material dynamic strength, otherwise significant inaccuracy might be induced.

The strain rate effect of elastic modulus of concrete beam

STRAIN RATE EFFECT ON DYNAMIC BEHAVIORS OF CONCRETE MEMBERS

Strain rate effect on uniaxial compressive behaviour of concrete columns

Experimental Studies on Concrete Filled Steel Tubes under High Strain Rate Loading

Strain-rate sensitivity of concrete: Influence of moisture content

Experimental investigation of the dynamic mechanical properties of concrete under different strain rates and cyclic loading

Effect of Testing Method and Strain Rate on Stress-Strain Behavior of Concrete

A Note on the Flexural Behavior of Concrete under Different Loading Rates

EFFECT OF STRAIN RATE ON THE BIAXIAL COMPRESSIVE BEHAVIOR OF CONCRETE

Study on Axial Tensile Strain Rate Effect on Concrete Based on Experimental Investigation and Numerical Simulation

Numerical analysis of concrete material properties at high strain rate under direct tension

Dynamic Properties of Concrete in Direct Tension

Research Progress of Strain-Rate Effect on Mechanical Properties of Concrete

STRAIN RATE EFFECTS ON THE BEHAVIOR OF CONCRETE AND THE SEISMIC RESPONSE OF CONCRETE STRUCTURES

Effects of Strain Rate on Reinforced Concrete Structure under Seismic Loading

A comparison of strain-rate enhancement approaches for concrete material subjected to high strain-rate

Influence of Initial Static Stress on the Dynamic Properties of Concrete

A microscopic approach to rate effect on concrete strength under combine load

Experimental Study on Elastic-Plastic Seismic Response Analysis of Concrete Gravity Dam with Strain Rate Effect

A Study of Strain-Rate Effect and Fiber Reinforcement Effect on Dynamic Behavior of Steel Fiber-Reinforced Concrete

Effect of initial static load on the rate-sensitive behavior of concrete in compression