Abstract:This present paper is focused on the study of the evaluation of the effluent chemical oxygen demand(COD) and nitrogen(N) based on the activated sludge model No.1(ASM1) through comparing the results with the modeling of traditional activated sludge processes.As is known,membrane bioreactors(MBRs) are attracting the whole global interest in water and sewage treatment because of its advantage of producing highly qualified effluent that can meet the commonly needed water quality regulations.However,due to the intrinsic complexity and instability of MBR processes,basic models are needed to provide a holistic understanding of the technology at a fundamental level and then compare the results of the treatment with the modeling of traditional activated sludge processes.The experimental results of our evaluation demonstrate that the influent COD and N in traditional Chinese medicine sewage proves quite different from that of domestic sewage.When compared with the experimental research and development,due to the commercialization of the technology,modeling studies for system design analysis and performance prediction are at a relatively rudimentary state.However,mathematical modeling of the biological performance of MBRs remains very limited in use,which has made us conduct a test in a membrane bioreactor(MBR) to treat high-strength traditional Chinese medicine(TCM) wastewater from two-phase anaerobic digest effluent.The experimental results we have gained demonstrate that the influent COD and N of traditional Chinese medicine wastewater were different to that of domestic sewage.The experimental results also demonstrate that readily biodegradable substrate(SS) proves 141.2 mg/L,with its slowly biodegradable substrate(XS) being 2 113.2 mg/L,particulate(XI) material being 85.3 mg/L,and soluble(SI) material ─ 53.8 mg/L.In addition,ammonia nitrogen(SNH) in the medicine was 20.93 mg/L,nitrate nitrogen(SNO) was 0.5 mg/L,soluble biodegradable organic nitrogen(SND) was 17.6 mg/L,particulate biodegradable organic nitrogen(XND) was 263.4 mg/L.COD and nitrogen(N) evaluation was input of ASM1 and its validity of evaluation was correlative to simulation results of ASM1.Thus,COD and N evaluation tends to be very important to the ASM1 model.Moreover,evaluation of COD and N may have the oriented and referential function for the similar sewage.And,therefore,it proves a real need to develop a model to predict and simulate the effluent COD quality and the process of membrane blocking.

Sensitivity analysis of ASM1parameters under different influent conditions

Sensitivity analysis of PM2.5 pollution to ammonia emission control in China

Sensitivity Analysis of Parameters of Storm Water Management Model with Sobol Method

Sensitivity and Uncertainty Analyses of an Extended ASM3-SMP Model Describing Membrane Bioreactor Operation

Modeling and Simulation of a Biological Process for Treating Different COD:N Ratio Wastewater Using an Extended ASM1 Model

Modeling and simulation of an extended ASM2d model for the treatment of wastewater under different COD: N ratio

Optimization of biological nitrogen removal in full-scale municipal WWTPs using activated sludge model simulation

Simulating a Cyclic Activated Sludge System by Employing a Modified ASM3 Model for Wastewater Treatment.

Modeling and simulation of the biological process for treating wastewater with a low COD:N ratio under different dissolved oxygen conditions using an extended ASM2d model

Simulation and optimization of ammonia removal at low temperature for a double channel oxidation ditch based on fully coupled activated sludge model (FCASM): a full-scale study.

On the Evaluation of the Sewage-Contaminated COD and N in Traditional Chinese Medicine Based on the Activated Sludge Model No.1

Modeling and Simulation of the Sequencing Batch Reactor at a Full‐scale Municipal Wastewater Treatment Plant

Evaluation of the effect of operational condition parameters on the large-scale V-ASP performance and system regulation measures

Optimal Parameter Estimation in Activated Sludge Process Based Wastewater Treatment Practice

BOD-DO simulation and parameter analysis of Songhua River watershed

Parametric Sensitivity Analysis for the Asian Summer Monsoon Precipitation Simulation in the Beijing Climate Center AGCM, Version 2.1

On Approaches To Analyze The Sensitivity Of Simulated Hydrologic Fluxes To Model Parameters In The Community Land Model

Steady-State Methodology for Activated Sludge Model 1 (ASM1) State Variable Calculation in MBR

Parameter Sensitivity to Concentrations and Transport Distance of Odorous Compounds from Solid Waste Facilities.

A generalized model for aerobic granule-based sequencing batch Reactor. 2. Parametric sensitivity and model verification.

Systematic Modeling of Municipal Wastewater Activated Sludge Process and Treatment Plant Capacity Analysis Using GPS-X