Abstract:A QC/T51-2006 standard country five-series road-sweeping vehicle is used as research object to improve the mechanization and work efficiency of a road sweeper and reduce the degree of environmental pollution. This study examines the flow of the fluid in an air duct of the sweeper during the working process and identifies the limitations of the original fan structure design. The sweeping air duct and structure are of optimized design. In accordance with considerable analyses and research, fluid simulation of the original air duct was conducted using the finite-element analysis software NX Nastran. A turbulence model is used to simulate the gas field inside the duct, ignoring the influence of temperature on the gas and wind pressure loss caused by a high-speed rotation of the fan. The entire duct was divided into two parts, namely, entrance and exhausted air ducts. In the model transfer process, the original assembly hole and welding plate were removed, and the unnecessary fillet and protruding structure were optimized. This approach was conducted to obtain the accurate value of wind speed in the suction port and outlet, which was compared with the starting velocity of dust particles and suspension speed. The flow field and streamline, velocity vector, and static pressure distribution of the original sweeper were obtained. Results show that through the data simulation analysis, the original sweater fan duct structure was optimized and its design was enhanced. This result increases the air duct speed by 50%. The fan power is reduced by 20 kW, thereby enhancing its efficiency. The energy saving is approximately 36.6%. The results provide data support and theoretical basis for the optimal design of the duct and structure. Furthermore, the results present theoretical and methodological support for the development of a new road sweeper.

Flow Field Analysis and Structure Optimization of Vacuum Sweeper Suction Mouth

Simulation for the Design of Dust Suction System of Highway Sweeper

Simulation for the Design and Optimization of Dust Collection Box of Highway Sweeper

Structural Parameter Optimization of Hydraulic Vertox Separator in Recirculating Biofloc Technology System Based on Computational Fluid Dynamics

Study on the Optimal Design for Cavitation Reduction in the Vortex Suction Cup for Underwater Climbing Robot

Simulation and Optimization of Fan System for Road Sweeper

Multi-objective optimization of a novel vortex finder for performance improvement of cyclone separator

DESIGN AND OPTIMIZATION OF A VACUUM SYSTEM FOR A LARGE STORAGE TANK CLEANING ROBOT

Three Dimensional Modeling and Numerical Simulation of Turbulent Flow Field Characteristics in Dust Removal Pipeline

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Enhancement of particle collection efficiency considering the structural interplay: particle motion characteristics analysis

Flow simulation and optimization on a new technic used to control dust from cold-rolled strip

Numerical Study on Particle Removal Performance of Pickup Head for a Street Vacuum Sweeper

Numerical Simulation and Analysis of Flow Field Characteristics for a 90-Degree Circular-section Dust Removal Pipeline

Numerical Simulation on Flow Field in a New Integrative Device for Dust Removal and Desulphurization

Simulation and test of flow process in air filter

Computational Fluid Dynamics Analysis of Wet Dust Removal in High-Gravity Countercurrent Rotating Packed Bed

NUMERICAL ANALYSIS OF A CENTRIFUGAL FAN FOR A ROAD SWEEPER

Simulation and Optimization of Flow Resistance and Noise Characteristics of Air-cleaner

CFD Based Design and Analysis of Micro-Structured Surfaces with Application to Drag and Noise Reduction

Numerical Investigation of Dusts Removal from Tramway Surface by Street Vacuum Sweeper