Abstract:Electrostatic precipitation processes have been widely applied to remove particulate matter from flue gases in coal-fired power stations. A high negative voltage is usually applied to a discharge electrode so that the gases are ionized in such processes. When the suspended particles in flue gases enter the ionized space, they are electrically charged and deposited on collection plates to form the layer of particle packing. However, the dust layer generally exists during the precipitation of charged particles on the collection plate. The negative effect of precipitated dust layer on the collection plate causes the collection efficiency of electrostatic precipitator (ESP) to deteriorate seriously due to some critical factors, such as dust resistivity and thickness of accumulated dust. In this study, a simulation method by computational fluid dynamics method was applied to investigate the particle collection performance of the ESP system with and without a dust layer. Also, the detailed electric parameters and particle capture performance in the 2D wire-plate electrode configuration were simulated. The results show that the voltage-current characteristics and detailed distribution of electric field and ion charge density are completely different under various dust resistivity conditions. The effect of the dust layer is significant, which causes collection efficiency to decrease sharply with the increasing thickness (1-5 mm) of the dust layer. Furthermore, results indicate that when particles with higher resistivity enter the ESP, their migration velocity decreases sharply. In the case of 80 kV, when the dust resistivity is 10(12)Omega.cm, the decline rate of particle migration velocity reaches 57.7%. Meanwhile, useful suggestions were provided to reduce the effects of dust layers by regulating particle properties and designing dust removal systems.

Numerical Investigation of Dusts Removal from Tramway Surface by Street Vacuum Sweeper

Numerical Study on Particle Removal Performance of Pickup Head for a Street Vacuum Sweeper

Prediction of Particle-Collection Efficiency for Vacuum-Blowing Cleaning System Based on Operational Conditions

Spatiotemporal migration of dust pollution during the tunnel mucking process and development of dust removal trolley based on computational fluid dynamics technology

Computational Fluid Dynamics Analysis of Wet Dust Removal in High-Gravity Countercurrent Rotating Packed Bed

Numerical Simulation Study on Air-Flow Migration Law about Vortex Air Curtain of Plane Wall Fan Drum

Simulation for the Design of Dust Suction System of Highway Sweeper

Simulation and Optimization of Fan System for Road Sweeper

Numerical Study on the Aerodynamic Performance and Safe Running of High-Speed Trains in Sandstorms

Study on air curtain cooperative spray dust removal in heading face based on swirl theory

Enhancement of particle collection efficiency considering the structural interplay: particle motion characteristics analysis

Research on the mechanism of multilayer spiral fog screen dust removal at the comprehensive excavation face

Experimental and numerical simulation study on forced ventilation and dust removal of coal mine heading surface

CFD Modeling of Ventilation and Dust Flow Behavior in Polishing and the Design of an Innovative Wet Dust Removal System

Evolutionary analysis of dust pollution in the comprehensive excavation face based on linear regression method

Dust Collection's Efficiency of Low Reynolds Purifier via Computational Fluid Dynamic Simulation and Optimization

Simulation for the Design and Optimization of Dust Collection Box of Highway Sweeper

Experimental and numerical evaluation of the dust suppression efficiency of an innovative vortex pneumatic fog screen dust control device

Numerical study on dust suppression and cooling performance of an external spray system in load-haul-dump vehicles

Numerical simulation and field test of dust control effect of exhaust ventilation in fully mechanized face

A Numerical Investigation of the Effect of Dust Layer on Particle Migration in an Electrostatic Precipitator