Abstract:Magnetic memory method (MMM) is widely used for diagnosing ferromagnetic material on early stage as a nondestructive technology, but no clear description exists for the influence of stress on MMM signals at the micro-defect position on the surface of steel wire yet. Hence, based on traditional magnetic charge model, a stress-dependent magnetic charge model that combined the Jiles magneto-mechanical constitutive relation was intended to calculate the MMM signals around micro-defect on surface of steel wire. Meanwhile, the Hp(y) signals on surface of steel wire with different defects were measured during the whole tension test. By comparing the results of theoretical model and experiment, some conclusions can be drawn. First, the position of vale-peak on Hp(y) signals curves can be used to determine the micro-defect on steel wire. Secondly, the vale-peak amplitude (Sv-p) and vale-peak width (Lv-p) of Hp(y) signals curves, as two characteristic parameters of magnetic signals, not only can reflect the variations of defect depth and defect width, but also judge the load subjected by specimen. Sv-p has an approximate growth with the increase of defect depth as a whole, but decreases with the increase of loads. And the effect of load on Sv-p increases with defect depth. Lv-p has an approximate growth with the increase of defect width as a whole, but does not change with the increase of loads. Finally, the stress-dependent magnetic charge model can be better to reflect the changing laws of Hp(y) signals around defect and can be used for the numerical analysis of MMM signals on surface of steel wire.

The Characteristics of the Magnetic Memory Signals under Different States for Q235 Defect Samples

The Characteristics of the Magnetic Memory Signal Under Different States for Q235 Steel Defect Samples

Study of magnetic signals behavior at groove defect by tensile stress during online measurement of Q345R steel

STUDY ON THE CHARACTERISTICS OF MAGNETIC MEMORY SIGNALS AT FERROMAGNETIC MATERIAL DEFECTS

Relationship Between Magnetic Memory Signal and Stress

Characterization of the Elastic-Plastic Region Based on Magnetic Memory Effect

Magnetic memory testing towards fatigue crack propagation of Q235 steel for remanufacturing

Relationship Between Residual Plastic Deformation and Metal Magnetic Memory Signals of Specimens

Distribution Characteristics Of Calculated Magnetic Charges Around Discontinuous Structures In Magnetic Memory Testing

Stress State Detection Based on Metal Magnetic Memory Theory

Critical Stress State Evaluation for Early Damage with Metal Magentic Memory Method

Theoretical and experimental study on metal magnetic memory technique

Stress-Dependent Magnetic Charge Model for Micro-Defects of Steel Wire Based on the Magnetic Memory Method

A Magnetomechanical Model for the Magnetic Memory Method

Effect of initial remanent states on the variation of magnetic memory signals

Fatigue Property of Steel Q235 Based on Metal Magnetic Memory Testing

Characterization of Magnetic Field in Crack Propagation Stage and Application to Non-Destructive Evaluation

Early damage stress state MMM testing

Research progress on magnetic memory nondestructive testing

Study of metal magnetic memory (MMM) technique using permanently installed magnetic sensor arrays

Study on physical mechanism of metal magnetic memory technique