Abstract:One of the basic problems in the design of polymer extrusion dies for multi-lumen micro profiles is the previously unknown extrudate swells, since they are more complex than those in axisymmetric extrusions. To investigate the three-dimensional extrudate swell of such geometries, numerical simulations and experiments are performed for the extrusion of a double-lumen micro profile using polypropylene. The selected profile exhibits typical non-axisymmetric geometry, uneven thickness and micro-scale dimension. A double convected pom–pom model considering the micro size effect is proposed to characterize viscoelastic properties of the polymer melt. Predictions are compared with experimental results as well as simulations using the power law model, and show the capacity of the proposed model for assessing the anisotropic swelling quantitatively. Influences of micro size effect, volumetric flow rate and material parameters on extrudate swell are investigated by parametric studies. It is found that swell ratios of various positions on the extrudate cross section are significantly different. The swelling anisotropy degree is enhanced with increasing volumetric flow rate as well as material parameters of second normal force coefficient and branching degree, while it is suppressed as the ratio of orientation to stretching relaxation time increases. The influence mechanisms of material parameters on extrudate swell are also discussed in detail. It is suggested that the anisotropic extrudate swell induced by micro size effect is significant and should be taken into account in high accuracy micro profile extrusions.

Swell and Sag Behavior in Annular Parison Extrusion of Polyethylene/ Polypropylene Blends

HDPE/PA6 blends: parison formation behaviour in extrusion blow molding

Numerical Prediction and Experimental Validation of Viscoelastic Annular Swell

Study on extrudate swell of polypropylene in double-lumen micro profile extrusion

The Melt Die-Swell Behaviour During Capillary Extrusion of Ldpe/Pp Blends

The polymer melt swelling behavior in micro-extrusion process for preparation of continuous carbon fiber reinforced PP prepreg filament

Study on mechanical properties and phase morphology of thermoplastic polyurethane/polypropylene blends prepared with vane extruder

Melt Die-Swell Behavior of Polyoxymethylene Blended with Ethylene-Vinyl Acetate Copolymer and High-Density Polyethylene

Rheological Properties and Morphological Evolutions of Polypropylene/Ethylene-Butene Copolymer Blends

Thermoplastic Polyurethane/polypropylene Blends Based on Novel Vane Extruder: A Study of Morphology and Mechanical Properties

Effect of annular expansion pipe extruder head on mechanical properties of pipes

Fast online acquisition and analysis for parison swell and sag in blow molding

Developing Laminar Morphology in Higher‐viscosity‐ratio Polyblends by Controlling Flow Fields in a Single‐screw Extruder

Rheology and Foaming Behavior of Linear Polypropylene/Low-Density Polyethylene Blends

Mechanical Properties and Morphology of LDPE/PP Blends

Morphology and Rheology of PP/POE Blends in High Shear Stress Field

Development of Polymer Blend Morphology along an Extruder with Different Screw Geometries

Morphology Study of Immiscible Polymer Blends in A Vane Extruder

Research on Extrusion Swell Behaviour of FEP/PP Blend Melt

Melt Extrudate Swell Behavior of Polypropylene Composites Filled with Hollow Glass Beads

The Morphology Control and Mechanical Properties of High Density Polyethylene and Polypropylene Blend under Oscillating Shear Stress Field