Abstract:The three-dimensional (3D) viscoelastic polymer melt filling process in injection molding has always been regarded as a challenging two-phase flow problem. Numerical investigations concerning it are very limited, especially under the non-isothermal condition. Thus, this article presents a 3D non-isothermal two-phase model to investigate the flow-induced stresses during the viscoelastic fluid filling process. The viscoelastic behavior of polymer melt is predicted by the eXtended Pom-Pom (XPP) model, in which the temperature dependence of polymeric viscosity and relaxation times are described using the Arrhenius equation. The 3D governing equations are solved by a collocated finite volume method. The high resolution revised level set method coupled with a domain extension technique is extended to capture the 3D melt front interface in an irregular cavity. The collocated finite volume method and the revised level set solver are respectively validated using the XPP melts past a cylinder and the single vortex flow. Then the ability of the presented 3D two-phase model is verified by the isothermal Newtonian fluid filling process in a thin rectangular cavity. The numerical results are in good agreement with those reported in literature. Finally, the challenging problem of non-isothermal XPP fluid filling process in a 3D rectangular cavity with one cylindrical insert is investigated. The temperature field, flow-induced stresses and the corresponding rheological behaviors of polymer melt during 3D filling process are quantitatively predicted. Especially, the effects of processing conditions and energy source term on the two normal stress differences are discussed. It is found that melt temperature and injection velocity are the main factors that affect the normal stress differences. The obtained results should be helpful for improving the product properties in practical production. (C) 2016 Elsevier Ltd. All rights reserved.

Numerical Prediction and Experimental Validation of Viscoelastic Annular Swell

Finite Element and Neural Network Modeling of Viscoelastic Annular Extrusion

Fast online acquisition and analysis for parison swell and sag in blow molding

Three-dimensional Simulations of Non-Isothermal Transient Flow and Flow-Induced Stresses During the Viscoelastic Fluid Filling Process

Swell and Sag Behavior in Annular Parison Extrusion of Polyethylene/ Polypropylene Blends

The polymer melt swelling behavior in micro-extrusion process for preparation of continuous carbon fiber reinforced PP prepreg filament

A New Short Die Swell Equation for Polymer Extrusion

A Three-Dimensional Thermal Model for Viscoelastic Polymer Melt Packing Process in Injection Molding

ADVANCES IN THE NUMERICAL INVESTIGATIONS ON EXTRUDATE SWELL OF VISCOELASTIC FLUID

Numerical Simulation of Polymer Filling Process by a Combined Finite Element/discontinuous Galerkin/level Set Method

Numerical simulation of extrudate swell of the IUPAC-LDPE melt by using Cross model

Modeling of Dynamic Extrusion Swelling Using Cross Model

Numerical simulation and experimental investigation on parison formation from a varying die gap in extrusion blow molding

Rheological Characterizations and Extrudate Swell Predictions of an LDPE Melt by Two KBKZ-type Constitutive Equations

Prediction Of Die Swell For A Ldpe Melt By Using Tanner Theory

Effect of the Vibration Force Field on the Polymer Extrusion Swell

Simulations of a Full Three‐dimensional Packing Process and Flow‐induced Stresses in Injection Molding

Study on extrudate swell of polypropylene in double-lumen micro profile extrusion

3D Numerical Simulation of Parison Inflation in Extrusion Blow Molding

Quasi-1D Modeling of Polymer Melt Die Swell in Short Dies

Numerical Simulation And Experimental Study Of Warpage Of Injection-Molded Parts