Abstract:Titanate nanotubes were synthesized hydrothermally from commercial TiO2 nanoparticles in the presence of NaOH; after calcination at 400°C, TiO2 nanotubes were obtained, which were used as the support to prepare manganese catalyst (MnOx/TiNT) by wet impregnation for the low-temperature selective catalytic reduction (SCR) of NO. The results of Brunauer, Emmett and Teller study, transmission electron microscopy, X-ray diffraction, and thermogravimetric measurements showed that TiO2 nanotubes exist in a well-defined TiO2 anatase phase after calcination at 400°C and that manganese particles are highly dispersed on the wall of TiO2 nanotubes. The effects of active-component loading, space velocity, oxygen content, [NH3]/[NO] ratio, and NO concentration on the SCR performance of MnOx/TiNT were investigated in a simulated flue gas. Under the reaction conditions of 150°C, [NH3]/[NO] of 1.2, [O2] of 3%, [NO] of 0.06%, gas hour space velocity of 23613.8 h−1, and Mn loading of 5–15%, NO conversion exceeds 95%. The catalyst is deactivated in the presence of H2O at 180°C, but its activity can be recovered almost completely by cutting off H2O. Moreover, higher resistance to H2O is observed at higher temperatures. The presence of SO2 can also deactivate the catalyst gradually; however, the catalyst shows better resistance to SO2 in the presence of H2O than in its absence. The SCR activity of the MnOx/TiNT catalyst that is deactivated by SO2 increases gradually after cutting off H2O and SO2 but cannot be restored to its initial level.

Relationship between SO2 poisoning effects and reaction temperature for selective catalytic reduction of NO over Mn–Ce/TiO2 catalyst

Temperature-Dependent Effects of SO2 on Selective Catalytic Reduction of NO over Fe–Cu–OX/CNTs–TiO2 Catalysts

Mechanism of SO2 Influence on Mn/TiO2 for Low Temperature SCR Reaction

SO2 Poisoning Behaviors of Ca-Mn/TiO2 Catalysts for Selective Catalytic Reduction of NO with NH3 at Low Temperature

Temperature sensitivity of the selective catalytic reduction (SCR) performance of Ce-TiO2 in the presence of SO2

Effect of ceria doping on SO2 resistance of Mn/TiO2 for selective catalytic reduction of NO with NH3 at low temperature

Sulfur/water resistance and regeneration of MnO -CeO2/TiO2 catalyst for low-temperature selective catalytic reduction of NO

Effect of SO2 on Activated Carbon Honeycomb Supported CeO2–MnOx Catalyst for NO Removal at Low Temperature

The role of cerium in the improved SO2 tolerance for NO reduction with NH3 over Mn-Ce/TiO2 catalyst at low temperature

The Effects of H2o and So2 on the Behaviour of Cuso4-Ceo2/Ts for Low Temperature Catalytic Reduction of No with Nh3

DRIFT Study of the SO2 Effect on Low-Temperature SCR Reaction over Fe−Mn/TiO2

Low Temperature Selective Catalytic Reduction of NO over Manganese Supported on TiO2 Nanotubes

DRIFT Study of the SO<sub>2</sub>Effect on Low-Temperature SCR Reaction over Fe−Mn/TiO<sub>2</sub>

Low-temperature Selective Catalytic Reduction of NO with NH3 over MnCe Oxides Supported on TiO2 and Al2O3: A Comparative Study

Low-temperature selective catalytic reduction of NO with NH3 over Mn–Ce–Ox/TiO2: a comparison between catalyst preparation methods

Getting insight into the influence of SO 2 on TiO 2 /CeO 2 for the selective catalytic reduction of NO by NH 3

Performance of Low-temperature SCR of NO with NH3 over MnOx/Ti-based catalysts

Promotion Effect and SO2 Tolerance of Sb-Modified Ce-Co/TiO2 Catalyst for Low-Temperature Selective Catalytic Reduction of NOx with NH3

Improvement of Activity and SO2 Tolerance of Sn-Modified MnOx–CeO2 Catalysts for NH3-SCR at Low Temperatures

Highly efficient NH3-SCR of NO over MnFeW/Ti catalyst at low temperature: SO2 tolerance and reaction mechanism

Improvement of sulfur and water resistance with Fe-modified S-MnCoCe/Ti/Si catalyst for low-temperature selective catalytic reduction of NO with NH3