Abstract:Two cases of abnormal acetylene content rise in the oil chromatogram of ultra-high voltage reactors are introduced in this paper. To monitor the internal condition of the reactor in real time and judge the type of defect， a partial discharge critical monitoring device is used for long-term monitoring. Critical monitoring results in case 1 show that there is a partial discharge caused by floating potential and weak insulation defects inside the reactor that lead to the rapid content rise of acetylene. Critical monitoring results in case 2 show that the intermittent partial discharge signal inside the reactor is an external interference signal near the north side of the ultra-high voltage reactors， and there is no obvious internal discharge signal. As to the iron core clamp ground current test， the internal defect type is the high temperature and overheating gas produced by the multi-point grounding of the magnetic circuit， and the chromatogram growth has nothing to do with the partial discharge. It is discovered by disassembly that the equipotential copper tape of the ground screen connected to the clamp on reactor body 1 in case 1 has broken discharge traces and the insulation paperboard is damaged. In case 2， the iron yoke of reactor body 1 and the magnetic shield of the upper body are overlapped， and the contact surface is obviously ablated with no obvious discharge trace inside， which excludes the possibility of internal discharge. The disassembly results are consistent with the analysis conclusions of the partial discharge critical monitoring system， verifying the effectiveness of the partial discharge critical monitoring method in power equipment defect analysis. The method can evade misjudgment due to external signal interference.

Application of Infrared Temperature Measurement Technology in Fault Diagnosis of Zinc Oxide Arresters

Thermal Defect of 220 Kv MOA by Infrared Diagnosis and Field Treatments Analysis

Application of Infrared Technology in Electrical Equipment Inspection

Infrared Technology-Based Sensor Data Analysis for Thermal Fault Identification of Electrical Equipment in Intelligent Substations

Substation Power Equipment Monitoring System Based on Infrared Detection

Temperature Compensation Method for Infrared Detection of Live Equipment under the Interferences of Wind Speed and Ambient Temperature

Application of X-ray Detection Technology in Routine Tests of High Voltage Bushings and Arresters

Inner Temperature Distribution of UHV GIS Using Infrared Thermo-diagnosis Technology

Interface Defect Detection for Composite Insulators Based on Infrared Thermography Axial Temperature Method

Research on Diagnosis Technology of Insulators Contamination Based on Impulse Current Detection and Infrared Thermography

Research and Application of Online Full Field of Infrared Temperature Measurement Technology

Early Warning Of Current-Carrying Faults Based On Deterioration Assessment Of Electric Contacts

Online Monitoring of Electrical Equipment Condition Based on Infrared Image Temperature Data Visualization

Infrared thermography‐based diagnostics on power equipment: State‐of‐the‐art

A Novel Reversible Thermometric Organic Material for Power Transmission Line Detection Application

ON-LINE TEMPERATURE MEASUREMENTS WITH INFRARED TECHNOLOGY ON HIGH VOLTAGE DEVICE

Design of Defect Identification and Location System for UHV AC Surge Arrester

Fault Diagnosis of Power Equipment Based on Infrared Image Analysis

Research on Live Detection Technology of Metal Oxide Surge Arresters

Application of Partial Discharge Critical Monitoring Technology in Internal Defect Detection of Ultra-high Voltage Reactors

Study on the Application of the Infrared Diagnosis Technology for the Electrical Equipment